User's Manual

Wireless Nano Router
www.phicomm.com
47
Appendix A: Troubleshooting
Appendix A: Troubleshooting
1. How do I restore the Wireless Nano Router to factory default settings?
When the Wireless Nano Router is powerd on, press and hold the reset button on the rear
panel for 8~10 seconds, after the light goes off, release the reset button.
2. What can I do if I forget my password?
 Restore the Wireless Nano Router to factory default settings. If you do not know how to do it,
please refer to previous section 1.
 Use the default username and password: admin, admin.
 Reconfigure the Wireless Nano Router since you have ever reset it, it is in AP mode by
default.
3. The wireless stations cannot connect to the Wireless Nano Router.
 Make sure the SSID Broadcast is enabled.
 Make sure that the wireless stations' SSID accord with the router's SSID.
 Make sure the wireless stations have the right password for encryption when the router is
encrypted.
 If the wireless connection is ready, but you can’t access the router, check the IP Address of
your wireless stations.
4. I cannot login the Wireless Nano Router’s web management page.
 Check the computer’s IP address, make sure the IP address is correct, for details please refer
to the section of Configure the Computer’s IP Address in this manual.
 Make sure you put 192.168.0.1 into the address bar, not the search bar.
 Check your web browser, make sure the Proxy server is unchecked. Take Internet Explorer as
an example, go to Tools>Internet Options>Connections>LAN Settings, uncheck Use a
proxy server for your LAN.
 If it tells you the username or password is error, and you cannot remember the new one,
please reset router by pressing reset button for at least 6 seconds, and then try to login with
default username and password (admin/admin).