™ your e3 survival guide
evolution is watching a baby develop.
nitty ` gritty nitty ` gritty bits ` bobs 2 one: wheeling ` dealing 3 two: swivel ` swerve 4 three: up ` running 5 four: handling 6 five: hooding up 7 six: insert baby 7 ups ` downs welcome to the adaptable ` delightful world of our boxes make a great distraction for your children while you get into the nitty ` gritty.
check your bits ` bobs You will need 1 x scissors c b 1 x adult (or someone who follows instructions!) d e Now just follow steps one to six... f a Open your e3 carton and check that the following bits and bobs are there double kit accessory (see page 10) This is often purchased with your e3 buggy; carton should contain the following bits and bobs a. 2 x rear wheels c b. 1 x top handle (with wrist strap attached) a c. 1 x main buggy d. 1 x front wheel e.
one: wheeling ` dealing 1. Take main buggy and lay flat (sunhood 5. Hold silver button in while inserting wheel axle into buggy frame. Line up down) as shown. silver button so it pops out of hole on frame. 2. Remove rear wheels from plastic bag (discard bag immediately – it is a suffocation hazard for children). 3. Use scissors to unwrap packaging around wheels (discard unwanted packaging). 4. Take one rear wheel and push in silver button on silver wheel axle. 6.
two: swivel ` swerve 1. Lift footwell as far as hinge will allow. 2. Remove front wheel from bag (the rod is greased so watch out for greasy fingers!). ` to lock the front wheel 1. Align silver button with small hole on inside of front wheel black cap. 3. Extend black 2. cap out fully underneath footwell and parallel with on underside rear wheels. of footwell and insert rod on front wheel. 4. Release cap. Your wheel will be in place for use.
three: up ` running 1. Turn buggy over onto 3 wheels. 2. Pull up rear frame. to fold 1. Press levers ‘a’ and ‘b’ (autolocks) on either side at bottom of frame seat with (Note: For double buggy do not lift frame using double seat as you may damage hinges.) 3. Make sure children are clear of buggy before folding, unfolding or adjusting the buggy. Watch fingers - injury may result. fingers whilst holding frame with palms Pull up until you hear a resounding ‘click’. of hands.
four: handling brakes Always apply brakes when parking your buggy. Brakes will be off when you unpack your buggy. Apply brakes before loading children. 4. 5. Now you’re up and running don’t let buggy Push handle in until you hear a clear ‘click’. Ensure buttons pop through get away on you - use brakes. 1. Line up handle with holes at top of frame. frame on both sides. Test drive buggy with handle in this position. Stand behind buggy and push brake lever down with foot. This will put brakes on.
five: hooding up 1. Pull up seat fabric and attach to Apply brakes and insert baby using safety lower snaps on handle – both left harness. (Ted stood in for baby!) and right side. 2. six: insert baby 1. Unclip 4 buckles on breastplate Attach snaps on back of sunhood to (circled in red) and place baby higher snaps on handle, both left and in buggy. right sides. 2. Adjust upper straps to fit snugly on baby’s shoulders. 3. Breastplate should sit snugly on your baby’s chest.
ups ` downs newborn buggy 4. (carry a newborn baby) 1. Undo zips fully on either side of With buggy set up ready to go, seat base for a apply brakes. completely flat newborn bed. 2. Undo 2 clips at back of seat, ‘a’ and ‘b’. 5. Lie baby flat in newborn position, facing forward, and secure baby firmly with adjusted safety harness. a using the clear plastic back flap b 1. 3.
ups ` downs toddler buggy 5. Attach clips at top of seat base to back of seat fabric. (carry a child) This position is generally comfortable for a child from 3-6 months, once child is strong recline seat enough to support its head. 1. Unzip zips inside seat to recline. Setting up from newborn baby position: 1. Remove and store clear plastic back flap. unzip 2. Do up zips on either side of seat base. 3. Move behind buggy and invert seat base so that clips at top of base show. 4.
ones ` twos baby ` toddler buggy (carry a newborn baby & child) Setting up the baby ` toddler buggy: 1. To use baby ` toddler position requires purchase of double kit accessory. 2. Double seat height can be adjusted by side tubes. 3. set of snaps. buggy (as shown). 4. Insert double seat into side tubes using and right are your left and right when standing plastic hinges ensuring silver buttons behind double seat with it facing forward). engage through buggy frame holes.
ones ` twos 5. Double seat will sit on main frame of buggy. To attach retaining strap on double seat: 1. Undo snaps at top of sunhood. 2. Push sunhood forward. 3. Attach retaining strap at back of double ensuring buttons pop through holes on frame. seat around main buggy frame using clip. 4. Reattach sunhood snaps. Buggy can be folded in this position. WARNING: Never use baby & toddler buggy without the retaining strap. Load heavier toddler in front seat first.
tricks ` treats buggy covers stormy weather & uv sunny days 1. Unfold cover carefully. 2. Place over sunhood. Attach around handle using snaps on each side of cover. 3. double stormy weather & uv sunny days 1. Unfold cover. 2. Place over sunhood and attach using the snaps around handle and snaps Attach cover to lower frame using at footwell. snaps on each side of buggy. Note that uv sunny days also has a mesh backflap - apply in the same way as the clear plastic backflap for newborn buggy. 3.
tricks ` treats coming soon! buggy cocoon pollution solution e3 cocoon The pollution solution buggy cover is made The cocoon is a light, portable carry-cot from a special mesh that protects baby which fits quickly and easily in buggy, so from the fine microns & particle matter in you can move a sleeping child to and from the city air. Now, doesn’t that make you buggy with no bother or fuss. breathe easier? 1. With buggy set up ready to go, apply brakes. 2.
tricks ` treats buggy storage blazing saddles 1. bacpac X Unpack and use Put it on your back or attach it to your buggy. hook/loop tape on 1. back to attach to side of buggy frame. 2. 2. Repeat for other side. buggy handle using snaps. 3. Attach round buggy side of buggy frame. and tighten straps. 4. Can also be used standing at back of buggy). for comfort on hips. a e3 travel bag Remove buggy wheels (and rear guards) to fit buggy into bag.
tricks ` treats buggy liners buggy bunny 1. Place in buggy and race seat 1. feed harness straps Feed harness shoulder straps through gaps. through D rings at top of race seat. woolly & warm 1. Feed harness straps through slots on rear of liner (cut new slots as required). sponge ted 1. Place in buggy and feed shoulder harness straps snuggle & snooze 1. through slots on sponge ted. Feed harness straps through slots on rear of sleeping bag.
™ ™ smartbuggy™ metoo ™ metro adapt ` survive! ™ ™ escape T2 tott
cuts ` bruises cleaning & caring for your e3 inner tubes and tyres are generally available unlike children, your e3 likes to stay clean. specialist wheel shops. Standard tyre kits can e3’s coat The fabric is backed with a water-resistant coating. Brush off dirt. More intense cleaning can be done by hand, in warm water, using a mild natural soap. Rinse out soap. Do not use detergents or bleach. Air dry.
rights ` remedies our warranty and service policy We want to give owners confidence in the quality of our products. They are warranted against defects in materials and workmanship for one year from the date of purchase. If the product has a manufacturing fault we will repair it free of charge. If not practical to repair it we will, at our discretion, replace the part in question*. If the product fails due to wear and tear, accident, neglect or negligence, or is Normal wear, fading and fabric cuts.
✄ return ` relax warranty form Name ™ Which most excellent product did you buy? Address e3 twin escape e3 smartbuggy metro T2 accessories metoo bebe e3 double kit pepe tott Date of purchase? / / Phone Rate from 1-10 how likely you would be to Email recommend this product to someone else? Just a few extra details to help us adapt ` survive! 1 2 3 4 5 6 7 8 9 10 Why? Your age? under 25 25-34 35-40 Number of children 1 2 3 3+ 40+ Any general suggestions? soon! Their a
affix stamp here ™ 102-112 daniell street newtown wellington 6002 new zealand
warnings ! Keep with your buggy for future reference. Injury may result if you do not follow all safety precautions. Injury may result from improper use. WARNING: Never leave children unattended, it may be dangerous. Take extra care with any child asleep in the buggy. WARNING: Ensure that all locking devices are engaged before use. WARNING: Any load attached to the handle affects the stability of the vehicle. Do not hang luggage or carry extra children on the buggy.
adapt ` survive! ™ safe ` sound we’ve attained the following safety standards as product safety is paramount to us: BS 7409:1996 AS/NZS 2088:2000 ASTM F833-01 head office +64 (4) 380 0833 fax +64 (4) 380 0137 address 102-112 daniell street wellington new zealand visit www.philandteds.