phil&teds tott Instruction Set GROUP 1+2+3 SUITABLE FROM 9 MONTHS – 11 YEARS APPROXIMATELY 9 to 36kg (20 to 79lbs) tott instructions assembling and installing your new phil&teds tott car seat is effortless, just follow these simple instructions and in 5 minutes you’ll be off.
safe & sound we’ve attained ECE R44/03 safety standard Instructions for fitting & use NOTICE 1. This is a “Universal” child restraint; it is approved to Regulation No. 44.03 series of amendments, for general use in vehicles and will fit most, but not all, vehicle seats. 2. A correct fit is likely if the vehicle manufacturer has declared in the vehicle handbook that the vehicle is capable of accepting a "Universal" child restraint for this group. 3.
16. It is most important that the seat belt is correctly routed and the child seat tightened down on the upholstery as firmly as possible to ensure maximum protection – a recommended method is shown in these instructions. 17. Never use this product if it has been in an accident, or if it has become badly worn. Periodically inspect the harness for wear, paying particular attention to attachment points, stitching and adjusting devices. 18.
fastening the harness: Slot the two metal sections of the buckle connectors together. Insert the two buckle connectors into the slot in the top of the buckle until they “click” into place. Always check that the harness is correctly locked by pulling the shoulder straps upwards. tightening the harness: To tighten the harness, pull down on the adjustment strap until the harness is the correct tightness. (The harness should be adjusted as tightly as possible without causing discomfort to the child.
Turn the webbing retainers on their narrowest end and feed them through the slots in the base of the seat and then through the slots in the fabric cover. fitting your car seat into the car WARNING: THIS CAR SEAT SHOULD NOT BE FITTED IN A PASSENGER SEAT OF A CAR THAT HAS AN AIR BAG FITTED (SRS) THE TYPE OF APPROVED SEAT BELT YOU MUST HAVE Your child seat can only be installed forward facing using a three-point lap and diagonal seat belt in the front or rear passenger seats of the car.
Step 1. Place the tott on the vehicle seat ensuring it is firmly pressed against the car seat backrest. Step 2. Thread the car seat belt in through the hole in the seat’s plastic backrest (on car door side), and then out through the hole on the opposite side and fasten it into the seat belt buckle. Step 3. Check the webbing of the seat belt has not become twisted or tangled and that the lap belt goes under the arm rest and diagonal belt covers armrest before proceeding. Step 4.
removing the seat backrest To remove the backrest, tilt it backwards and release it from the armrests, then push further towards the ground (in one swift movement) until it releases from the booster seat. The backrest will release when it reaches a 20˚ - 30˚ angle from the ground (initially this may need some force). fitting the booster seat recommended for use by children from 22kg – 36kg (approx.
removing the backrest cover: pull the plastic button at the back of the backrest cover off the backrest. Take it out from the back of the backrest cover. Slide the cover off. The covers can now be cleaned. removing the booster seat cover: first, remove the seat backrest. Release the elastic strap, slide the cover off. The covers can now be cleaned. cleaning the covers: use mild hand soap and warm water. Do not use chemical cleaners and never attempt to bleach or dye the webbing. Always dry fabric naturally.