Operation Manual

20
EN
1A23
ADVANCED OPERATION
Selecting Display Mode
STB allows you to select a display mode to match the
formats of the program being broadcast on your TV
screen.
Display Mode
1 Press [SETUP] to display “SETUP”
menu.
2 Select “DETAIL” using [K
/ L], then
press [OK].
SETUP
EXIT
CHANNEL
TIME
DETAIL
INITIAL
CLOSED CAPTION
DISPLAY MODE
AUTO POWER DOWN
V-CHIP
4 HOURS
LETTERBOX
3 Select “DISPLAY MODE” using [K / L],
then press [OK].
DETAIL
EXIT
CHANNEL
TIME
DETAIL
INITIAL
CLOSED CAPTION
DISPLAY MODE
AUTO POWER DOWN
4 HOURS
LETTERBOX
V-CHIP
4 Select the desired display mode using
[K / L], then press [OK].
Select display mode
ZOOM
FULL
LETTERBOX
5 Press [SETUP] to exit “SETUP” menu.
INFORMATION on Display Mode
For standard 4:3 TVs displaying widescreen
16:9 broadcasts, your choices are:
4:3 TV screen 16:9 broadcast
LETTERBOX
Displays the entire picture image while
fitting the picture to the screen by applying
gray bars to the top and bottom of the
screen.
No information will be lost.
ZOOM
Expands the picture image to fill the screen
while cropping some images on the left
and right.
Picture information on the left and right
side will be lost.
FULL
Displays the entire picture image while
fitting the picture to the screen by
stretching the image vertically, so that it
fills the screen.
No information will be lost, but there may
be a slight distortion of the picture.
CAUTION:
•
If the TV is left in LETTERBOX mode for a
long period of time, the gray bars may cause a
permanent burn-in effect.
Setting the Time Zone and DST
(Daylight Saving Time)
To get the EPG (Electronic Program Guide) and
Channel banner, you will need to set “TIME ZONE”
and “D.S.T” correctly.
1 Press [SETUP] to display “SETUP”
menu.
2 Select “TIME” using [K
/ L], then press
[OK].
X6032UD_Book.indb 20X6032UD_Book.indb 20 11/28/2007 4:34:41 PM11/28/2007 4:34:41 PM