User Manual

(Bit Address+Destination End Point = 0x05) (Bit Address =0
；
Destination End Point
= command owner Endpoint value)
Command Class = 0x32 (Command_Class_Meter_V3 = 0x32)
Command =0x02 (Meter_Report = 0x02)
Parameter 1 = 0x21 (Scale Bit2 = 0
，
Rate Type = 0x01
，
Meter Type=0x01)
Parameter 2 = 0x34 (Precision = 1
，
Scale Bit1Bit0 =
0x02
，
Size = 4)
Parameter 3 = 0x00 Instant Power Consumption =
0x000003EA
= 100.2W
Parameter 4 = 0x00
Parameter 5 = 0x03
Parameter 6 = 0xEA
2-3-5-3 Get load voltage V from endpoint
Meter_GET example:
COMMAND_CLASS_MULTI_CHANNEL
MULTI_CHANNEL_CMD_ENCAP
Source End Point = 0x05 (this is the endpoint of command owner,
here we assume endpoint is 5
，
if the
owner doesn’t support multi Channel this
value will be 0)
(Bit Address+Destination End Point =
0x03)
(Bit Address =0
；
Destination End Point
range1~3)
Command Class = 0x32 ( Command_Class_Meter_V3 = 0x32)
Command =0x01 (Meter_Get = 0x01)
Parameter 1 = 0x20 (Scale = V = 0x04)
PAN04 AC load Voltage report example
：
COMMAND_CLASS_MULTI_CHANNEL
MULTI_CHANNEL_CMD_ENCAP
Source End Point = 0x03 (Meter report = Endpoint3)
(Bit Address+Destination End Point = 0x05) (Bit Address =0
；
Destination End Point
= command owner Endpoint value)
Command Class = 0x32 (Command_Class_Meter_V3 = 0x32)
Command =0x02 (Meter_Report = 0x02)
Parameter 1 = 0xA1 (Scale Bit2 = 1
，
Rate Type = 0x01
，
Meter Type=0x01)
Parameter 2 = 0x22 (Precision = 1
，
Scale Bit1Bit0 =
0x00
，
Size = 2)
13