User Manual

Meter_Get
Current
Relay1 I1+Relay2 I2
Meter_Get Power factor PF Relay1
3-3-2 Selected Endpoint 2
Similar like Selected Endpoint 1 but only relate to Relay1 and ignore Relay2
3-3-3 Selected Endpoint 3
Similar like Selected Endpoint 1 but only relate to Relay2 and ignore Relay1
3-4 Edge and Pulse mode
Manual switch S1 and S2 can set to Edge mode or Pulse mode or Edge-Toggle
mode , default value is Edge mode.
Edge mode: this mode is suitable for the bi stable wall switch that has indicator point
on the switch, and the same position correspond to same state of relay1 and relay2 .
if the PAN04 relay change the state because of receiving Z-Wave RF command, it
may need two times of change (switch on to off or switch off to on) to let relay back
to the correspond state.
Pulse mode: this mode is suitable for the toggle type wall switch to swap the state of
Relay1 or Relay2
Edge-Toggle mode: this mode is suitable for the normal bi-stable switch, every time
when change the state of the wall switch will also swap the state of Relay1 or Relay2
3-5 Threshold of Watt for Load Caution
This is a warning when the wattage of load over the preset threshold value, If the
setting value is 1500, when the load wattage of Relay1 or Relay2 over this value,
PAN04 will send Watt Meter Report command to the node of correspond Group.
3-6 Threshold of KWh for Load Caution
This is a warning when the KWh of load over the preset threshold value, If the
setting value is 10000, when the Accumulated Power Consumption of Relay1 or
Relay2 over this value, PAN04 will send KWh Meter Report command to the node of
correspond Guoup, minum value is 1KWh and default value is 10000 kWh
4.
Command Classes
The Switch supports Command Classes including…
* COMMAND_CLASS_SWITCH_BINARY
* COMMAND_CLASS_BASIC
* COMMAND_CLASS_MANUFACTURER_SPECIFIC_V2
* COMMAND_CLASS_VERSION
* COMMAND_CLASS_SWITCH_ALL
* COMMAND_CLASS_ASSOCIATION_V1
* COMMAND_CLASS_METER_V3
* COMMAND_CLASS_CONFIGURATION
* COMMAND_CLASS_MULTI_CHANNEL_V3
* COMMAND_CLASS_ALARM
Note: Please make sure that the intensity of the plug of the electrical device must be
16A and have same head as the enclosed plug before inserting to the socket.
17