User Manual

the Switch turns on.

[Command Class Basic, Basic Set, Value = 0(0x00)]: the load attached to

the Switch turns off.

[Command Class Switch Binary, Switch Binary Set, Value = (255)0xFF]:

the load attached to the Switch turns on.

[Command Class Switch Binary, Switch Binary Set, Value = 0(0x00)]: the

load attached to the Switch turns off.

2. Z-Wave’s Groups (Association Command Class Version 1)

The Switch can be set to send reports to control associated Z-Wave devices. It

supports 3 association groups which every group has one node support.

Group1~Group3 support SWITCH_BINARY_REPORT,

METER_REPORT_COMMAND_V3

For group 1, the Switch will report (1) ON/OFF status of Relay1 and Relay2 (2)

Instant Power Consumption (Watt) of Relay1 and Relay2 (3) Accumulated Power

Consumption (KWh) of Relay1 and Relay2 to Z-Wave Controller.

For group 2, the Switch will report (1) ON/OFF status of Relay1 (2) Instant Power

Consumption (Watt) of Relay1 (3) Accumulated Power Consumption (KWh) of Relay1

to Z-Wave Controller.

For group 3, the Switch will report (1) ON/OFF status of Relay2 (2) Instant Power

Consumption (Watt) of Relay2 (3) Accumulated Power Consumption (KWh) of Relay2

to Z-Wave Controller.

2-1 Auto report to Grouping 1 ~3(Maximum Node 1)

2-1-1 On/Off Event Report

When “on” or “off ” state has been changed by pressing S1 S2 or on/off button, it

will send Binary Switch Report to the nodes of Group1~3. But if “on” or “off ” state

has been changed by RF command (ex. Switch Binary set

、

All Switch ON/OFF or

Basic Set), it will not send.

Binary Switch Report

ON:[Command Class Switch Binary, Switch Binary Report, Value

=(255)0xFF]

OFF:[Command Class Switch Binary, Switch Binary Report, Value

=0(0x00)]

2-1-2 Instant Power Consumption vary over 5% report

When the power consumption of load vary over 5%, it will send Meter report to the