User Manual

Command =0x03 (Switch_Binary_Report = 0x03)
Parameter 1 = 0xFF (ON=0xFF
，
OFF=0x00)
2-2-2 BINARY_SWITCH_SET
By using BINARY_SWITCH_SET Command of Multi Channel Command Class
Encapsulation Command, you can switch both Relay1 and Relay2 ON/OFF by
setting endpoint to 1 or switch Relay1 ON/OFF by setting endpoint to 2 or switch
Relay2 ON/OFF by setting endpoint to 3
The example of the command show that switch off relay1 of PAN06
COMMAND_CLASS_MULTI_CHANNEL
MULTI_CHANNEL_CMD_ENCAP
Source End Point = 0x01 (this is the endpoint of command owner
here we assume endpoint is 1
，
if the
owner doesn’t support multi Channel this
value will be 0)
(Bit Address+Destination End Point = 0x02) (Bit Address =0
；
Destination End Point
range1~3)
Command Class = 0x25 (Command_Class_Switch_Binary =
0x25)
Command =0x01 (Switch_Binary_Set = 0x01)
Parameter 1 = 0x00 (ON=0xFF
，
OFF=0x00)
3. Z-Wave’s Configuration
Configuration
Parameter
Function Size
(Byte)
Value Unit Default Description
1 Slected
End Point
1 1-3 1 1
：
Relay1 &
Relay2
2
：
Relay1
3
：
Relay2
2 Edge or
Pulse
mode or
Edge-
Toggle
mode
1 1-3 1
1：Edge mode
2：Pulse mode
3：Edge-Toggle
mode
3-1 Selected Endpoint
If Controller not using Multi_Channel command class to access the endpoint of
PAN06, you may configure the endpoint value to react the Basic Command Class
or Binary Switch Command Class.
3-1-1 Selected Endpoint 1
：
Default Selected Endpoint is 1
Set command Relay state
Basic Set or Binary_Switch_Set ON Relay1 ON &
6