User Manual

Detector cannot control
the Switch
2. Same frequency
interference
LED keep flashing, but
cannot control
Overload occurs Remove the load attached or check
max. load cannot exceed
1550W~17000W
Specification
Operating Voltage 100~240VAC / 50-60Hz
Maximum Load 1500W for UL/TW/JP
Range Minimum 30 m in door 70m outdoor line of sight
Operating Temperature 0°C ~ 40°C
Frequency Range 908.42 MHz /UL; 922~926 MHz /TW/JP
** Specifications are subject to change and improvement without notice.
FCC ID : RHHPAN11
Warning:
1.Plug out to disconnect from power supply; Do not plug in line.
2. Do not exceed the max rating
Disposal
This marking indicates that this product should not be disposed with
other household wastes throughout the EU. To prevent possible harm to
the environment or human health from uncontrolled waste disposal,
recycle it responsibly to promote the sustainable reuse of material
resources. To return your used device, please use the return and
collection systems or contact the retailer where the product was
purchased. They can take this product for environmental safe recycling.
Company of License Holder
：
Philio Technology Corporation
Address of License Holder
：
8F.,No.653-2,Zhongzheng Rd., Xinzhuang Dist., New
Taipei City 24257,Taiwan(R.O.C)
FCC Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital de-
vice, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to
radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to cor-
rect the interference by one of the following measures:
•
Reorient or relocate the receiving antenna.
10