User's Manual

PHILIO Z-Wave Utility Manual
9.1.How to Send Command
First select the device that you want to send the command to it.
Note: The NID: 255 is for broadcast.
Figure 12 Select the device
Select the command that you want to send.
Figure 13 Select the command
Before you send out the command, you must make sure the Z-Wave device is
in sleep mode or not. If the device is sleeping, it won’t receive any command.
Usually you can press some button to wake up the device.
At the top of control panel, there are two options. First one is “Send
Instantly”, if the device is awake, you can check this option, after you click the
Philio Technology Corporation Page 17
CONFIDENTIAL