User's Manual

ManualsBrandsPhilio Technology ManualsElectronicsMulti Sound Siren

Multi Sound Siren PSE02

The multi sound siren PSE02 is a wireless siren, based on Z-Wave

technology. Z-Wave

is a wireless communication protocol designed

for home automation, specifically to remotely control applications in

residential and light commercial environments. The technology uses a

low-power RF radio embedded or retrofitted into home electronics

devices and systems, such as lighting, home access control,

entertainment systems and household appliances.

This device is one component of the Z-Wave

system and is designed

to work with all other Z-Wave

enabled devices in a home control

network. The device adopt the Z-Wave

400 series chip, when your Z-

Wave

network system is all made by Z-Wave

400 series devices. The

network system will have the advantages as below.

• Concurrent multi-channel support reduces external interference.

• Better RF range, improve about 10 meters in indoor.

• Support 100 Kbps transmit speed, speed up communication.

Product Overview

Adding to Z-Wave

Network

There are one tamper key behind the device. It could inclusion,

exclusion, reset or association from Z-Wave

network.

In the first time, add the device into the Z-Wave

network. First, make

sure the primary controller is in the inclusion mode. And then power on

the device. The device will auto start the NWI (Network Wide Inclusion)

mode. And it should be included in 5 seconds. You will see the LED

light ON one second.

Function

Description

Inclusion

1. Have Z-Wave

Controller entered inclusion mode.

2. Pressing tamper key three times within 1.5 seconds

will enter inclusion mode.

3. After inclusion successful, the device will wake to

receive the setting command from Z-Wave

Controller about 20 seconds.

Siren

Tamper Key

Circle Button

Battery

(Optional)

DC Jack

Summary of content (4 pages)

PAGE 1
Product Overview Multi Sound Siren PSE02 Circle Button DC Jack Siren Battery (Optional) The multi sound siren PSE02 is a wireless siren, based on Z-WaveTM technology. Z-WaveTM is a wireless communication protocol designed for home automation, specifically to remotely control applications in residential and light commercial environments.
PAGE 2
Notice 1: Always RESET a Z-WaveTM device before trying to add it to a Z-WaveTM network. 1. Have Z-WaveTM Controller entered exclusion mode. 2. Pressing tamper key three times within 1.5 seconds Exclusion will enter exclusion mode. Node ID has been excluded. 1. Pressing tamper key four times within 1.5 seconds and do not release the tamper key in the 4th pressed, and the LED will turn ON. 2. After 3 seconds the LED will turn OFF, after that within 2 seconds, release the tamper key.
PAGE 3
Play Sound Manual Battery Shutdown The device supports using BASIC SET or SWITCH_MULTILEVEL SET to play the sound. The sound ID is define as follow: 1: Emergency sound. 2: Fire alert. 3: Ambulance sound. 4: Police car sound. 5: Door chime. 6~99: Beep Beep. 0: means stop the sound, but will check the priority. When the DC power is dropped. The system will auto switch to use the battery power. If you want to really shutdown the system, please follow instructions as below. 1.
PAGE 4
Specifications can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. Power by DC 5V, and support backup lithium battery (Optional).