Installation Instructions

Monoxide sensor will not work if the battery power is disconnected or
cut off for any reason. Additionally, carbon monoxide must reach the
CO alarm unit for the proper performance of CO gas detection.
Carbon monoxide alarms may wear out because they contain
electronic parts that fail at any time. Test your CO alarm at least every
week (see the section "TEST AND SILENCE YOUR CO ALARM").
Add to/Remove from Z-Wave
TM
Network
There is one button on the device. It can be used to add, remove, reset
or association from Z-Wave
TM
network.
In the first time, add the device into the Z-Wave
TM
network. First, make
sure the primary controller is in the add mode. And then insert battery to
power on the device. Press the button once to start the NWI (Network
Wide Inclusion) mode. And it should be added in 5 seconds.
Notice: Including a node ID allocated by Z-Wave
TM
Controller means
“Add” or “Inclusion”. Excluding a node ID allocated by Z-Wave
TM
Controller means “Remove” or “Exclusion”.
Function Description
Add
1. Have Z-Wave
TM
Controller entered inclusion mode.
2. Pressing button three times within 1.5 seconds to
enter the inclusion mode.
3. After add successful, the device will wake to receive
the setting command from Z-Wave
TM
Controller
about 20 seconds.
Remove
1. Have Z-Wave
TM
Controller entered exclusion mode.
2. Pressing button three times within 1.5 seconds to
enter the exclusion mode.
Node ID has been removed.
Smart Start
1. Product has a DSK string , you can key in first five
digit to increment smart start process,or you can
scan QR code.
Ex:mydsk
10209-46687-52248-13629-04783-07465-15776-56519
2. SmartStart enabled products can be added into a Z-
Wave network by scanning the Z-Wave QR Code
present on the product providing SmartStart
inclusion. No further action is required and the
SmartStart product will be added automatically
within 10 minutes of minutes On in the network
vicinity.
Reset
Notice: Use this procedure only in the event that
the primary controller is lost or otherwise
inoperable.
1. Pressing button four times within 1.5 seconds and
do not release the button in the 4
th
pressed, and the
red LED will light ON.
2. After the red LED flash 9 times, release the button
within 2 seconds.
3. IDs are removed and all settings will reset to factory
default.
Association
1. Have Z-Wave
TM
Controller entered association
mode.
2. Pressing button three times within 1.5 seconds to
enter the association mode.
Note: The device support 1 groups. This group is for
receiving the report message, like triggered event etc.
This group support 8 nodes maximum.
2