Installation Instructions

• Failed or success in add/remove the node ID can be viewed
from Z-Wave
TM
Controller.
Notice 1: Always RESET a Z-Wave
TM
device before trying to add it to a
Z-Wave
TM
network
Z-Wave
TM
Notification
After the device adding to the network, it will wake-up once per day in
default. When it wake-up it will broadcast the “Wake Up Notification”
message to the network, and wake-up 10 seconds for receive the
setting commands.
The wake-up interval minimum setting is 30 minutes, and maximum
setting is 120 hours. And the interval step is 30 minutes.
If the user want to wake-up the device immediately, please press the
button once. The device will wake-up 10 seconds.
Z-Wave
TM
Message Report
When CO Sensor detects, the device will report the trigger event and
also report the battery status.
In default the device will using Notification Report to represent the
trigger event, it can be changed to Sensor Binary Report by setting the
configuration NO. 7 Bit4 to 1.
* CO Detected/Test Report:
When the CO Sensor detects CO, the device will unsolicited to send
the CO detected (0x02) report to the nodes in the group 1. When the
device is in alarm test mode, the device will unsolicited to send the CO
Sensor test (0x03) report to the nodes in the group 1.
Notification Report (V4)
Notification Type: CO (0x02)
Event: CO detected, Unknown Location (0x02)
CO Alarm Test (0x03)
Sensor Binary Report (V2)
Sensor Type: CO (0x03)
Sensor Value: 0xFF
* Tamper Report:
When the tamper is pressed, the device will into the alarm state. In that
state, if tamper is released, the yellow LED will light on and the device
will unsolicited to send the report to the nodes in the group 1.
Notification Report (V4)
Notification Type: Home Security (0x07)
Event: Tampering. Product covering removed (0x03)
Sensor Binary Report (V2)
Sensor Type: Tamper (0x08)
Sensor Value: 0xFF
Notice : When the event triggered, the device will report the messages
to the nodes in the group 1. The messages also include the tamper
status.
Power Up Procedure
* Wake
When the device power on, the device will wake about 20 seconds. In
3