Installation Instructions

this duration, the controller can communicate with the device. Normally

the device is always sleeping to save the battery energy.

Over The Air (OTA) Firmware Update

The device support the Z-Wave firmware update via OTA.

Let the controller into the firmware update mode, and then press the

button once to start the update.

Please don't remove the battery, otherwise it will cause the firmware

broken, and the device will no function.

After update finish, it is recommended that the user power up the

device. Caution: After remove the battery, please wait about 30

seconds, and then re-install the battery.

INSTALLING YOUR CO Sensor

Philio Carbon Monoxide Sensor PSG04 is easy to install to protect you

and your family in your home, cottage, cabin and office.

To install the CO Sensor (See figure 2 as below):

1. At the place where you are going to install the alarm, draw a

horizontal line six (6) inches long.

2.Remove the mounting bracket from your unit by rotating it

counterclockwise.

3.Place the bracket so that the two longest hole slots are aligned on

the line. In each of keyhole slots, draw a mark to locate a mounting

plug and screw.

4.Remove the bracket.

5.Using a 3/16-inch (5mm) drill bit, drill two holes at the marks and

insert wall plugs.

6.Using the two screws and wall plugs (all supplied), attach the bracket

to the wall.

7.Line up the side slot of the bracket and the alarm. Push the alarm

onto the mounting bracket and turn

INSTALLING / REPLACING BATTERY

To install or replace the batteries in your CO Sensor PSG04, please

perform the following steps:

1. Gently press the transparent locker (see figure 3 as below) and flip