User's Manual

2
C. The full color LED will flash once with pink every 10 second when
countdown from 30.
D. The full color LED will flash with pink light every 1 second when
countdown from 5.
E. The red LED will flash 6 times with white when time’s up.
Z-Wave Network Setting Up
There is a touch button on the front side. The button carry out inclusion,
exclusion and reset to default.
1. Include: Pointing the arrowhead to area A first (shown in Fig. 2). Pressing
the button three times within 1.5 seconds. The red LED will light up for 1
second if succeed.
2. Exclude: Pointing the arrowhead to area A first (shown in Fig. 2). Pressing
the button three times within 1.5 seconds.
3. Reset to default: Pointing the arrowhead to area A first ((shown in Fig. 2)).
Pressing button four times within 2 seconds and hold at fourth. The red LED
will light for 3 seconds, release the button within 2 seconds while the LED
go out. The LED will flash for 1 second if reset succeed, or LED will flash
once
. Build-in Buzzer
1. Turn light on: Beep once.
2. Turn light off: Long beep once.
3. Timer:
A. Beep once for setting up the timer.
B. Long beep once for stop counting down.
C. Beep once every ten seconds for countdown from thirty.
D. Beep once every per second for countdown from five. Four times
beep and repeat six times when time’s up.
Fig. 2 Control Area
Fig. 3 Timer Table
A
C
B
D