User's Manual

4
Troubleshooting
Symptom
Cause of Failure
Recommendation
The Switch not working and
LED off
1. Battery dead
2. Device break
1. Charging the battery by Micro
USB.
2. Don’t open up the Switch and
send it for repair.
Can not adjust the
percentage of dimmer or
thermostat
The device may not be
placed upright.
Check if the device is placed
upright.
The device can not join to
Z-Wave network
The device may has
joined to a network.
1. Exclude the device then include
again.
Button no response The button will no
response when LED is
flashing
Wait for the LED go out and try
again.
Specification
Operating Voltage 3.7 V (Lithium Polymer Battery)
Low Battery Voltage 3.6 V
Range Minimum 40 m in door, 100m outdoor line of sight
Operating Temperature -10°C ~ 45°C
Frequency Range PSR04-1: 868.40MHz; 869.85MHz(EU) /
PSR04-2: 908.40MHz; 916.00MHz(USA/Canada) /
PSR04-3: 922.5MHz/ 923.9MHz/ 926.3MHz (Taiwan/JP)
** Specifications are subject to change and improvement without notice.
FCC ID : RHHPSR04
Warning:
1. Plug out to disconnect from power supply; Do not plug in line.
2. Do not exceed the max rating
Disposal
This marking indicates that this product should not be disposed with
other household wastes throughout the EU. To prevent possible harm to
the environment or human health from uncontrolled waste disposal,
recycle it responsibly to promote the sustainable reuse of material
resources. To return your used device, please use the return and
collection systems or contact the retailer where the product was
purchased. They can take this product for environmental safe recycling.
Company of License Holder：Philio Technology Corporation
Address of License Holder：8F.,No.653-2,Zhongzheng Rd., Xinzhuang Dist.,
New Taipei City 24257,Taiwan(R.O.C)
FCC Interference Statement
FCC Interference StatementFCC Interference Statement
FCC Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference
in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to
radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.