User's Manual

7) Video Configuration
This page is to configure every channel with various conditions.
(1) Video Channel State Control
Administrator decides whether to utilize video signal from selected channel in NetServer or not. If
user disables a channel with an external camera connecting to NetServer, NetServer does not show
any image from the channel. If user enables a channel without connecting an external camera to
NetServer, NetServer is interrupted and cannot transmit image properly (transmission speed goes
down).
(2) Camera Color Type
It is to define every camera whether it is color or B/W camera. This is not to change its original
character but only to define the character and give information to NetServer.
(3) Camera Signal Type
It is to define whether the signal of external dome camera is ‘NTSC’ or ‘PAL’.
(4) Camera Installation Angle
NetServer can always show images in right angle regardless a dome camera’s installation position.
If a dome camera is located on the floor upside down, user can adjust image angel by selecting ’180
deg’.