User's Manual

Accel.
To control the moving speed of the Pan / Tilt mechanism. There are three settings, denoted by the small
graphic located between the “+” and “ —“ signs. “Accel.” does not control zooming speed. This can be
adjusted with the mouse. By clicking the right mouse button on the image, a pop-menu with five options
will appear. The “Focus Sensitivity” controls zooming speed from level 1 to 10.
PLAY/STOP
NetCam-2 generates and transfers the real-time images as soon as it is accessed. To stop transferring images,
click the “STOP” button. To resume transfer, click “PLAY” button.
(4) Transmission Control
Gray Mode
Images are displayed in black and white. Images can be transmitted at a higher speed under gray mode.
Progressive Mode
Every image is regenerated from low to high resolution. In other words, an image is reproduced from vague
to clear. This function is useful when using a low speed network such as a dial up phone modem.
Single Shot Mode
When this button is clicked, one frame of image is reproduced. Therefore, no other images may be viewed.
To go back to the real-time images, click the button again
(5) Image Control
Resolution
To control the resolution level. Higher resolution levels reduce frame rate.
Extension
To see images in different sizes from 1X to 4X. However, Extension (2X to 4X) does not increase image’s
resolution. Therefore, the quality of extended image is not as clear as original image.
Frame Rate
To control image transmission speed. The “Fastest” setting will receive images at the fastest speed possible,
based on network line capacity and PC capability.