User's Manual

Bluetooth Headset User’s Manual
6
Switching off
• Press the main button until a short tone is heard in the earpiece
• Release the button, the headset will generate the switch off melody
• The LED will stop flashing
Preparing the headset for use - Pairing
Note – default PIN for engineering samples is 1234
Before the headset can communicate it must be paired to the companion device it will be used
with, such as a mobile phone. This is to ensure the headset only communicates with the device
chosen by the user and not any other Bluetooth devices in range.
Pairing information is stored by the headset, and can be changed at any time
The exact process to pair the headset will also depend on the device it is paired with. The
user manual for that device will give instructions on how to do this. In all cases the headset
will need to be put into pairing mode, which is described here.
• If the headset is on, switch it off
• Press and hold the main button
• When the short tone is heard, keep the button pressed until the pairing melody is
generated
• The LED will flash alternate red/green
• Follow instructions for the companion device to pair to the headset
• When prompted on the companion device enter the PIN code for the headset
• When paired the headset will give a short confirmation tone and switch to standby
ready for operation
Receiving a and ending a call
• To receive a call the headset must be in standby mode
• When a call is received the headset will generate a ringing signal in the earpiece.
• The call may be answered by a short press of the main button
• The connection will be made to the companion device and in the case of a mobile
phone the call will be answered
• During call, when in talk mode the microphone may be muted and un muted by a
medium press of the main button
• A short press of the main button will end a call
Initiating a call
• When in standby mode a short press will initiate a connection to the companion device
• For example this could be used to initiate a call with a mobile phone