User's Manual

PHILIPS 802.11a/b MiniPCI Card WLAN
42
DRAFT
8 REGULATORY INFORMATION
• To identify this product refer to the part or model number on the product label
8.1 Federal Communications Commission (FCC)
FCC Modular Labeling Requirements:
The modular transmitter must be labeled with its own FCC ID PUBWCM1008, and, if the
FCC ID is not visible when the module is installed inside another device, then the outside
of the device into which the module is installed must also display a label referring to the
enclosed module. This exterior label can use wording such as the following: “Contains
Transmitter Module FCC ID: PUBWCM1008” or “Contains FCC ID: PUBWCM1008.”
FCC Notice:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for
help.