Manualshelf

User's Manual

ManualsBrandsPhilips Consumer Electronics ManualsElectronicsTransDock Classic - In-car FM transmitter for iPod
12345678
Setting Preset Stations
Follow these simple steps to set your own preset stations:
1. Using the Tuning Buttons, tune TransDock Classic to the station that you’d like to save
as a preset.
2. Press and hold the Preset Button on the right side of TransDock Classic for a few
seconds to save that station as a preset channel. The display on TransDock Classic will
flash the preset channel you just set (e.g., CHO1).
3. Press the Preset Button to cycle to the next preset channel. Repeat steps
1 and 2 for all available preset channels (up to four).
NOTE: Your new preset will override whatever preset was last saved on that channel.
Controlling the OLED Backlight
TransDock Classic features an indigo blue backlit OLED display. The backlight comes
on automatically when you power up TransDock Classic, and any time you change
frequencies. The backlight automatically turns off after two minutes.
You can also manually operate the backlight by pressing the Backlight Button on the left
side of TransDock Classic. If the backlight is already on, pressing this button will
immediately turn it off. If the backlight is off, pressing this button will turn the backlight
on indefinitely. To turn it off, press the Backlight Button again.
TransDock Classic Intelligent Power Control
TransDock Classic features Intelligent Power Control, meaning TransDock Classic turns
on automatically when you plug it in or when you connect your iPod, and automatically
shuts off when not in use for two minutes. This feature is ideal for cars whose auto power
outlet continues to draw power, even when the car is off. TransDock Classic will turn
itself off – protecting your car’s battery.
NOTE: TransDock Classic will not turn off as long as a player or device is attached.
To manually power down TransDock Classic, hold the Backlight Button down for several
seconds. This will completely turn off TransDock Classic until you manually turn it on
again or it automatically turns on as described above. To manually turn TransDock
Classic back on, press and hold the Backlight Button for three seconds.