User's Manual

17
You can now communicate with the »
caller.
Adjust the earpiece volume
Press
call ID
or
Ph.Boo
k
to adjust the volume during
a call.
The earpiece volume is adjusted and »
the phone is back to the call screen.
Turn the speaker on or off
Press .
Make a second call
Note
This service is network dependent. •
1 Press
flash
T A L
K
during a call, then press [OK].
The rst call is put on hold. »
2 Dial the second number.
The number displayed on the screen is »
dialed out.
Answer a second call
Note
This service is network dependent. •
When there is a periodical beep to notify you
of an incoming call, you can answer the call in
these ways:
1 Press
flash
T A L
K
and to answer the call.
The rst call is put on hold, and you »
are now connected to the second call.
End a call
You can end a call in these ways:
Press • END; or
Place the handset to the charging cradle if •
the auto hang up is activated.
Answer a call
When the phone rings. Press
flash
T A L
K
or to answer
the call.
Warning
When the handset rings or when the •
handsfree is activated, keep the handset away
from your ear to avoid ear damage.
Note
The caller ID service is available if you have •
registered to the caller ID service with your
service provider.
When there is a missed call, the handset
displays a notication message.
Turn off the ringer for all incoming
calls
There are two ways to turn off the ringer:
1 Press and hold in standby mode.
»
displays on the screen.
2 When the phone rings, press [SILENT].
Mute the microphone
1
Press mute during a call.
The handset displays » [MUTE ON].
The caller cannot hear you, but you »
can still hear his voice.
2 Press mute again to unmute the
microphone.
English
EN