User's Manual

59
Advanced settings
13.7 Unregister
1 Press m in idle mode, scroll n to
Advanced Set and press
o
Select .
2 Scroll
n to Unregister and press
o Select.
3 Enter the PIN when prompted and
press
o OK to confirm.
4 Scroll
n to select the handset
number to unregister and press
o
Select. Press o OK to confirm.
• A validation tone is emitted to
indicate successful unregistration.
You can only use a SE659 handset to
unregister a handset that does not
belong to the SE659 range.
13.8 Reset Unit
You can reset your phone to its default
settings with this feature. (see 13.15
“Default Settings”)
Upon reset, all your personal settings,
call log and redial list entries will be
deleted and the phone will return to its
default settings. However, your
phonebook will remain unchanged after
reset.
You may have to configure your phone
once again.
1 Press m in idle mode, scroll n to
Advanced Set and press
o
Select .
2 Scroll n to Reset and press
o
Select .
3 Reset? is displayed on the screen.
Press
o OK to confirm.
• A validation tone is emitted.
• The unit is reset to its default
settings. (See section 13.15
below.)
13.9 Set Area Code
This feature is useful when you have
subscribed to Caller Line Identification
service. It allows you to set an area code
in your phone. Once the local area code
is set, the phone automatically filters the
area code for all incoming calls, by
removing the area code for local calls and
retaining the area code for calls from
other areas.
If it is a local call, then only the phone
number of the caller is displayed during
an incoming call or when you call the
number from the call log. If it is a long
distance call, then both the area code and
phone number will be displayed in a
proper format to be dialed out directly
from the call log, or saved into the
phonebook.
You can enter 3 digits for the area code.
You need to subscribe to Caller Line
Identification service to be able to see
the caller’s number or name in the call
log. See 8.1.4 “Call from the call log” for
details.
1 Press m in idle mode, scroll n to
Advanced Set and press o
Select.
2 Scroll n to Area Code and press
o Select.
Note
Caution
Note
Note