User's Manual

12
Getting started
4 Getting started
4.1 Connect the base station
Place the
base station in a central location
near the telephone line socket and electricity
socket.
4.1.1 Install the base support
Place the base station face down so that you
can see the bottom of the base station.
Attach the base support to your base station
by fitting the tabs of the base support into the
corresponding slots on the base unit.
Push into place until a click sound is heard.
To remove, simply pull the base support away
from the base unit.
4.1.2 Connect the line cord and power cable
Connect the line cord and the power cable to
their corresponding connectors at the bottom
of the base station as shown.
Connect the other end of the line cord to the
telephone line socket and the other end of
the power cable to the electricity socket.
Note
The line adaptor may not be attached to the line
cord. In this case, you have to connect the line
adaptor to the line cord first before plugging the
line cord to the line socket.
Warning
Avoid placing the base station too close to large
metal objects such as filing cabinets, radiators or
electrical appliances. This can impair the range
and sound quality. Buildings with thick internal
and external walls may impair transmission of
signals to and from the base.
Warning
The base station does not have an ON/OFF
switch. Power is applied when the power adaptor
1
1
2
3
Bottom of
the base
support
4
1
2
SE745_IFU_EN.book Page 12 Monday, March 26, 2007 8:41 PM