User's Manual
Table Of Contents
- Contents
- Introduction
- General description (Fig. 1)
- Intended use
- IMPORTANT SAFEGUARDS
- Using the body analysis scale
- Preparing for use
- Measuring weight and body fat
- Performing a measurement
- Cleaning and storage
- Accessories
- Disposal
- Assistance
- Full Two-Year Warranty
- Troubleshooting
- Specifications
- Electromagnetic emissions and immunity
- EMC Guidance
- Table 1 Guidance and manufacturer's declaration – electromagnetic emissions - for all ME equipment and ME systems
- Table 2 Guidance and manufacturer's declaration – electromagnetic immunity – for all ME equipment and ME systems
- Table 4 Guidance and manufacturer's declaration – electromagnetic immunity –for ME equipment and ME systems that are not life supporting
- Table 6 Recommended separation distances between portable and mobile RF communications equipment and the ME equipment or ME system – for ME equipment and ME systems that are not life supporting
- FCC Compliance information
your weight and perform BIA. You can also upload your measurement data
to the health app later on, when the scale and your mobile device are
connected. Results of the body analysis measurement can only be accessed
using the Philips HealthSuite health app. The scale cannot directly
communicate BIA results to the user.
1 Step onto the scale barefoot to switch it on. The device beeps to indicate
it is ready for weighing.
-
You can take a measurement barefoot. The device is able to perform the
weight measurement and the BIA measurement and later on store the
measurement data in the health app. Make sure your feet are clean and
slightly damp.
-
You can also take a measurement wearing footwear. The scale is only
able to perform the weight measurement and not the body fat estimation
and BMI calculation. Your measurement results will not be stored or sent
to the health app.
2 Weight measurement starts.
-
Weight is shown on the display of the device after weight
measurement ends.
3 BIA measurement starts (when measuring barefoot).
-
The symbol 'BIA' flashes on the display to indicate the device is
analyzing your data.
4 Stand still and keep full contact with the measurement platform until the
symbol ‘BIA’ stops flashing. The device beeps to indicate that the
measurement is completed. The results of the BIA will not be shown on
the display.
5 The device is equipped with user profile recognition and automatically
selects the user based on their weight.
-
When the device immediately displays the weight: no user is
recognized and results are not stored. See below for instructions.
-
When the device shows multiple users: more users are recognized
based on your weight. See below for instructions.
6 The measurement results are stored in the device in case of a successful
BIA.
-
The device can store up to 40 measurement results for each user
profile. The oldest results will be replaced by new measurement
results.
7 After measuring, step off the device. It switches off automatically.
When the device does not automatically recognize the correct
user profile:
16
English