User's Manual
Table Of Contents
- Contents
- Introduction
- General description (Fig. 1)
- Intended use
- IMPORTANT SAFEGUARDS
- Using the body analysis scale
- Preparing for use
- Measuring weight and body fat
- Performing a measurement
- Cleaning and storage
- Accessories
- Disposal
- Assistance
- Full Two-Year Warranty
- Troubleshooting
- Specifications
- Electromagnetic emissions and immunity
- EMC Guidance
- Table 1 Guidance and manufacturer's declaration – electromagnetic emissions - for all ME equipment and ME systems
- Table 2 Guidance and manufacturer's declaration – electromagnetic immunity – for all ME equipment and ME systems
- Table 4 Guidance and manufacturer's declaration – electromagnetic immunity –for ME equipment and ME systems that are not life supporting
- Table 6 Recommended separation distances between portable and mobile RF communications equipment and the ME equipment or ME system – for ME equipment and ME systems that are not life supporting
- FCC Compliance information
d = 1.167 ÖP 80 MHz to 800MHz
d = 2.333 ÖP 800 MHz to 2.5 GHz
where P is the maximum output power rating of the transmitter in watts (W)
according to the transmitter manufacturer and d is the recommended
separation distance in metres (m).
Field strengths from fixed RF transmitters, as determined by an
electromagnetic site survey (a), should be less than the compliance level in
each frequency range (b).
Interference may occur in the vicinity of equipment marked with the
following symbol:
NOTE 1 At 80 MHz and 800 MHz, the higher frequency range applies.
NOTE 2 These guidelines may not apply in all situations. Electromagnetic
propagation is affected by absorption and reflection from structures, objects
and people.
(a) Field strengths from fixed transmitters, such as base stations for radio
(cellular/cordless) telephones and land mobile radios, amateur radio, AM
and FM radio broadcast and TV broadcast cannot be predicted theoretically
with accuracy. To assess the electromagnetic environment due to fixed RF
transmitters, an electromagnetic site survey should be considered. If the
measured field strength in the location in which the device is used exceeds
the applicable RF compliance level above, the device should be observed
to verify normal operation. If abnormal performance is observed, additional
measures may be necessary, such as re-orienting or relocating the device.
(b) Over the frequency range 150 kHz to 80 MHz, field strengths should be
less than 3V/m.
Table 6 Recommended separation distances between
portable and mobile RF communications equipment and the
ME equipment or ME system – for ME equipment and ME
systems that are not life supporting
Recommended separation distances between portable and mobile RF
communications equipment and the device.
The device is intended for use in an electromagnetic environment in which
radiated RF disturbances are controlled. The customer or the user of the
device can help prevent electromagnetic interference by maintaining a
minimum distance between portable and mobile RF communications
equipment (transmitters) and the device as recommended below, according
to the maximum output power of the communications equipment.
Separation distance according to frequency of transmitter (m)
Rated maximum output
power of transmitter (W)
150 kHz to 80 MHz
d = 1.167 Ö P
80 MHz to 800 MHz
d = 1.167 Ö P
800 MHz to 2.5 GHz
d = 2.333
0.01 0.117 0.117 0.233
23
English