User's Manual



Specificationsaresubjecttochangewithoutnotice

1.3 RF Pairing
The(re)pairingprocedureisonlyneededtoreplaceadefectiveitemorwhenfactorresethasbeen
initiated.
RFpairingisbyproximitypairingmethod,whichboththeREMOTECONTROLandreceiverneedstobein
RFPairingmodeandbringwithin2meters
(Configurabledistance)apartfromthereceiver.
TheReceiverpairingcanbeenabledbythreemethods:Pressbutton,PluginUSBorviasoftware
controller.WheneveraREMOTECONTROLinPairingModeiswithinpairingproximity,bothREMOTE
CONTROLandReceiverwillbepaired.

1 Press and hold KEYBOARD keys “BACK” and “HOME” for 3 secs.
2 Bring the REMOTE CONTROL within 2 meters distance from the host and make sure
no other REMOTE CONTROL is in pairing mode
3 POWER LED will start blinking fast during RF Pairing mode.
4 Enable pairing on USB dongle: 3 methods are available (can be used simultaneously)
• Plug-in Pairing
• Button paring
• Host-command (Software) pairing
There are 2 timeouts:
• Virgin-pairing – When first time pairing, timeout is 30 minutes
• Normal pairing – Timeout is 30 seconds
All timeouts are adjustable in the configuration file.
Enable Plugin and Button pairing are configurable in config file. Default all enabled.
Distance pairing is available (will only pair with devices within certain range)
Press pairing button on USB dongle, or (re) plug USB cable in host system.
5 Upon completion of pairing, the POWER LED will stop blinking and the REMOTE
CONTROL will exit the RF Pairing mode.

1.4 RF Auto Connection
WhentheRFwakesuporresumesfromSLEEP/STANDBYorcomebackwithinrangeofapoweron
pairedReceiver,RFlinkwillbere‐connectedautomatically.NoRFre‐pairingisneeded.
1.5 RF Out of Range
WhentheRFlinkisbroken,remotecont rol willgo toSLEEPmodeafter10seconds(configurabletime).





