User's Manual

2. Linking LivingColors lamps
1. You can operate multiple LivingColors with one remote control
. The LivingColors lamps will
then project the same color (or will change colors simultaneously). In order to link several
LivingColors to one remote control, bring the remote close to the Philips logo on the top of the
lamp and press on “I” (“On”). LivingColors will flash 3 times, and then shortly flash in green color.
You can release the button now. The linked lamps will turn to the last setting of the remote
control.
- Repeat this operation for each LivingColors lamp that you want to link with the others.
- To use the LivingColors separately again, link it to another remote control in the same way as
described above.
2. It is also possible to control one LivingColors lamp with several remote controls
. In order to do
so, first reset one of the remotes by pressing and holding the “0” and the (icon brightness down)
buttons simultaneously for 5 seconds. Then hold two remote controls close to each other and
press the “I” button on both for 7 seconds. You can now link the new remote control to the
LivingColors in the same way as described above.
- LivingColors that are linked to two (or more) remote controls can be controlled by either remote
control.
- To unlink a remote control from a LivingColors, hold the remote control close to the LivingColors
and press “0” for three seconds. The LivingColors will flash 3 times. Hold the “0” button a little
longer and it will slowly fade to off. The remote control and the LivingColors are now unlinked.
3. Compatibility with timers
You can use LivingColors with a timer (not included). When switched on with a timer, the
LivingColors will show your last setting (static color or automatic color-changing mode)
Fault tracing
:
Problem Possible cause Solution
Check connections of the cord to the lamp The lamp is not plugged
in correctly
Check if the plug is correctly placed in the wall
socket
LivingColors is not
providing light
Remote control is not
working
See the following section
Remote control is not
working
Check the batteries in the remote control. The
batteries should be rightly placed (+ and -)
and should be loaded. If the remote control is
still not working, try replacing the batteries.
Remote control is not
linked to the lamp
Link the remote to the LivingColors lamp by
following the procedure under “2. Linking
LivingColors lamps”
Move LivingColors away from the wireless
access point
LivingColors does not
respond to the remote
control
Heavy traffic on a
wireless data network
(e.g. wireless router)
Make sure that all LivingColors connected to
this remote are on; otherwise they will not
respond after this action.
Press simultaneously on “0” and (icon
saturation up) for at least 5 seconds to switch
to another channel (all LivingColors will flash
green to confirm). You can repeat this
procedure up to 3 times, preferrably from
another position.