User guide
5
EN
INTRODUCTION PREPARATION
WATCHING TV
OPTIONAL SETTING TROUBLESHOOTING
INFORMATION
Supplied Accessories5
AAA
AAA
If you need to replace these accessories, please refer to the part No. with the illustrations and call our toll free 
customer support line found on the cover of this manual.
•
Attaching the Stand
You must attach the stand to the unit to display upright. Be sure the front and rear of the stand match the proper direction.
5
Note:
  • When attaching the stand, ensure that all screws are tightly fastened. If the stand is not properly attached, it could cause the unit to fall, 
resulting in injuries as well as damage to the unit.
  • Make sure to use a table which can support the weight of this unit and is larger than this unit.
  • Make sure the table is in a stable location.
1
  Spread a thick and soft cloth over a 
table.
Place the main unit face down 
onto it. Make sure not to damage 
the screen. At least two people are 
required at this step.
2
  Hang the hook under the bottom 
of the main unit to the stand’s hole 
(shown arrow 
➀
), then slide down 
the stand in the direction of the 
screen (shown arrow 
➁
).
Make sure not to put the AC power 
cord between the stand and the 
unit.
3
  Drive Phillips pan screws in the 4 
threaded holes at the bottom of the 
stand with a screwdriver tightly.
To remove the stand from this unit
Unscrew the Phillips pan screws indicated by “
➂
”. Pull up the stand in the direction of the rear of the unit. Be careful not to drop the stand 
when you remove it.
front side
Symbols Used in this Manual
The following is the description for the symbols used in this manual. Description refers to:
TV
: Analog TV operation
DTV
: Digital TV operation
• If neither symbol appears under the function heading, operation is applicable to both.
5
Trademark Information
HDMI, the HDMI logo and High-Definition Multimedia Interface are trademarks or registered trademarks of HDMI 
Licensing LLC.
Manufactured under license from Dolby Laboratories. “Dolby” and the double-D symbol are trademarks of Dolby 
Laboratories.
Products that have earned ENERGY STAR® are designed to protect the environment through superior energy efficiency.
5
•
•
•
 screw holes
 screw holes
user manual
(1EMN24339)
quick start guide
(1EMN24479)
remote control
(NF802UD)
batteries
(AAA x 2) 
registration card
(1EMN24699)
Phillips pan screw for 
attaching the stand x 4
(FPH34200)










