User's Manual

AP Configuration Information
IntelliVue Telemetry System 1.4 GHz Core Access Point/Remote Antenna Installation Guide 2-
35
AP Configuration Information
Refer to the IntelliVue Telemetry System Infrastructure Installation and Service
Guide (M3185-91934) for complete details about configuring the IntelliVue
Telemetry System AP.
Access Point Startup Sequence
Upon power on/start up, the ITS Core Access Point will perform a Power-on-Self-Test
(POST) to ensure that its basic components are fully functional.
This test detects critical system failures. As the test progresses the state of the
system is displayed through a series of color combinations on the Power/Sync,
Radio, and Network LEDs on the front of the AP. All three LEDs illuminate AMBER
color, then the Power/Sync LED illuminates GREEN and the other two LEDs turn off
(not illuminated) indicating correct startup. Should a test fail the LEDs are left in a
state which indicates the point at which the test failed. When the system is
transmitting data the radio and network LEDs on the AP will flicker on and off as
data is transmitted.
Figure 2-23: Mounting the RA Below a Ceiling Tile (Quick Release
Bend Down
Tighten Collar
DRAFT-3