User's Manual

Troubleshooting the Remote Antenna Using its LEDs
IntelliVue Telemetry System 1.4 GHz Core Access Point/Remote Antenna Installation Guide 3-
3
- L
ink LED - Link present/Ethernet connection. Lights GREEN (ON) when a
pass-through link is present - OFF when not present.
- A
ct LED - Wired network activity. Flashes GREEN (ON) when there is activity is
over the wired network.
• W
ireless/RF Activity - The AP provides three LEDs to indicate wireless/RF
activity. During normal operation, these LEDs indicate the following information:
- P
ower/Sync LED - GREEN (ON) when power and synchronization signal is
present.
- R
adio LED - Normally OFF (not lit) - flashes green to indicate wireless network
activity.
- N
etwork LED - Normally OFF (not lit) - flashes green to indicate wired network
activity.
• R
emote Antenna - The Core AP provides two LEDs on each RJ-45 UTP cable
connector that provides status on a connected Remote Antenna:
- R
A Connection - Lights GREEN to indicate a RA is connected to the Core AP.
- RA Power - Lights YELLOW to indicate connected RA is receiving power from
the Core AP.
If the Status LED indicators are not functioning properly as indicated then perform
the appropriate troubleshooting procedures. If you cannot resolve the problem with
the LEDs, then make written note of the LED lighting and sequence of colors,
replace the unit, and send the defective unit back to Philips with the explanation of
LEDs sequence and colors displayed. Refer to Chapter 4 of the IntelliVue Telemetry
System Infrastructure Installation and Service Guide for complete AP replacement
procedures.
Troubleshooting the Remote Antenna Using its LEDs
Complete test and inspection procedures for the IntelliVue Telemetry System 1.4
GHz Remote Antenna are given in Chapter 4 of the IntelliVue Telemetry System
Infrastructure Installation and Service Guide. You must perform these procedures
when the Philips IntelliVue Telemetry System is initially installed and after any
service event.
Figure 3-1 shows the location of the ITS 1.4 GHz Remote Antenna LEDs.
A summary of the Remote Antenna’s status LEDs is given below to help you
troubleshoot any operational problems that may arise.
Figure 3-2: IntelliVue Telemetry System Remote Antenna LEDs
UTP Cable Connector
to Core AP
Connection LED
(Green)
Power LED
(Yellow)
DRAFT-3