User's Manual
Table Of Contents
- Introducing IntelliVue Telemetry
- Product Safety
- Transceiver Controls
- Basic Operation
- Alarms
- ECG Monitoring
- ST/AR Arrhythmia & ST Segment Monitoring
- SpO2 Monitoring
- Telemetry Functions at the Information Center & TeleMon
- Pairing with IntelliVue Patient Monitors
- Maintenance, Cleaning & Troubleshooting
- Safety Standards & Specifications
- Accessories
- Sales and Support Offices
Cleaning
2-14 Product Safety
WarningWarning
Removal of the SpO
2
sensor during Continuous SpO
2
monitoring results in
a "No Sensor" technical alarm. Silencing this technical alarm turns the
SpO
2
measurement off. There is no technical alarm for a “No Sensor”
condition in Spot Check mode.
WarningWarning
This equipment is not suitable for use in the presence of a flammable
anesthetic mixture or oxygen concentrations greater than 25% (or partial
pressures greater than 27,5 kPa /206.27 mmHg).
Cleaning
WarningWarning
EO is highly explosive, toxic, and a potential occupational carcinogenic and
reproductive hazard. Handle it with extreme care, following U.S.
Occupational Safety and Health Administration (OSHA) standards for EO
(29 CFR 1910.1047)
*
. Personnel exposure and/or room air must be
monitored per OSHA standards.
Vent sterilizer gas outdoors or to a suitable, evacuated container for
reprocessing, depending upon state, provincial, or country environmental
regulations. Do not vent sterilant indoors.
Vent aerator exhaust only to the outdoors.
* See “References” on page 11-9.