User's Manual
Table Of Contents
- Introducing IntelliVue Telemetry
- Product Safety
- Transceiver Controls
- Basic Operation
- Alarms
- ECG Monitoring
- ST/AR Arrhythmia Monitoring
- SpO2 Monitoring
- Telemetry Functions at the Information Center & TeleMon
- Telemetry Functions at the Information Center
- Telemetry Controls in the Patient Window
- Locating the Transceiver (Find Device)
- Viewing Device Location in the Patient Window (optional)
- Viewing Device Location History (optional)
- Using the Device Location Client (optional)
- Patient Configurable Settings in Telemetry Setup
- Unit- Configurable Settings
- RF Auto Shutoff
- Transceiver Operation when Connected to TeleMon
- Telemetry Functions at the Information Center
- Pairing Monitoring Devices
- Maintenance, Cleaning & Troubleshooting
- Safety Standards & Specifications
- Accessories
- Sales and Support Offices
Technical Alarms (INOPs)
5-18 Alarms
SpO
2
T NOISY SIGNAL
Source - Telemetry
Hard Excessive patient
movements or electrical
interference are causing
irregular pulse patterns
Reduce movement or
electrical noise sources.
SpO
2
T NON-PULSATILE
Note—When paired
directly with an IntelliVue
MP5 Patient Monitor, the
INOP will display as
SpO
2
T SENSOR OFF.
Source - Telemetry
Hard Pulse is too weak or not
detectable
Check connection to patient.
Change sensor site. Avoid
site distal to BP cuff or intra-
arterial line.
SpO
2
T SENSOR MALF
Source - Telemetry
Hard Malfunction of the SpO
2
sensor/adapter cable
Replace sensor.
TAAP DISABLED
Source - Patient Monitor
Hard The monitor’s telemetry
configuration does not
allow connection of the
transceiver to the monitor.
Check configuration settings
at the monitor.
Contact Service.
TELE CONFIG
UNSUPPORTED
Source - Patient Monitor
Hard Transceiver not supported
(companion mode).
Make sure the transceiver is
the correct revision.
Contact Service.
Technical Alarms (Inoperative Conditions)
Alarm Text Priority Condition What to do