User's Manual

Device Usage
Philips Telemonitoring Set 37
Do not measure your glucose while your Glucose Meter is connected to the
TeleStation.
Clean your finger of blood before using the TeleStation.
Note For procedures on how to measure your glucose with your Glucose Meter refer to
its Instructions for Use manual.

Recording
Glucose
Measurements
Follow these steps to send your Glucose Meter measurements to your healthcare
provider’s computer via the TeleStation:
Step 1. Measure your glucose with your Glucose Meter following the procedures
given in its User Guide.
Step 2. Wait for the meter to turn off. The meter will turn off automatically when
the strip is discarded.

For the Bayer Ascensia Contour meter, this can take 3 minutes. OneTouch
meters will stay on and should be left on.
Step 3. Clean your finger of any residual blood before the next step.
Step 4. Connect the large end of the Glucose Meter Cable to the. connector
marked
| 0 | 0 | on the back of the TeleStation. The Glucose Meter may
already be connected.
Step 5. Connect the single pin connector on the other end of the Glucose Meter
Cable into the data port on the Glucose Meter. Press firmly to make sure the
connector is pushed in all the way. The TeleStation will not detect the
Glucose Meter until the meter is turned on.
Note The Glucose Meter Cable for the supported Bayer Contour meter is different from
the Cable for the supported
Lifescan OneTouch meters. See the following figure