User's Manual

Philips Medizin Systeme Böblingen GmbH

Hewlett-Packard-Strasse 2, 71034 Böblingen, Germany, Telefon +49(0)7031 463-0, Telefax +49(0)7031 463-2202

Geschäftsführer: Dr. Dieter Haase (Sprecher), Dr. Felix Baader, Klaus Baumann

Registergericht Stuttgart Reg.-Nr. HRB 245187, Sitz der Gesellschaft: Böblingen

www.philips.com/healthcare

Page 1 of 3

07-Feb-17

WLANBV3-A WLAN Module User’s

Manual

Product: WLANBV3-A WLAN Module

Model: WLANBV3-A

FCC ID: PQC-WLANBV3

IC: 3549C-WLANBV3

For OEM integration only – device cannot be sold to general public. Therefore we will not supply a

User’s manual.

We will ask OEM to include the following Notices required by FCC/ IC on the product and in the User’s

manual.

Notifications

FCC ID: PQC-WLANBV3

IC: 3549C-WLANBV3

NOTICE

Federal Communication Interference Statement (United States only)

This equipment has been tested and found to comply with the limits for a class B digital device, pursuant

to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses, and can radiate radio

frequency energy and, if not installed and used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no guarantee that interference will not occur

in a particular installation. If this equipment does cause harmful interference to radio or television

PAGE 1
WLANBV3-A WLAN Module User’s Manual Product: WLANBV3-A WLAN Module Model: WLANBV3-A FCC ID: PQC-WLANBV3 IC: 3549C-WLANBV3 For OEM integration only – device cannot be sold to general public. Therefore we will not supply a User’s manual. We will ask OEM to include the following Notices required by FCC/ IC on the product and in the User’s manual.
PAGE 2
Notifications reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • • • • Re-orient or relocate the receiving antenna Increase the separation between the equipment and receiver Connect the equipment to an outlet on a circuit different from that to which the receiver is connected Consult the dealer or an experienced radio/TV technician for help This device and its antenna(s) must not be c
PAGE 3
Notifications 102 de l’IC. Cet équipement doit être installé et utilisé en gardant une distance de 20 cm ou plus entre le dispositif rayonnant et le corps (à l’exception des extrémités : mains, poignets, pieds et chevilles). Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada.