User manual

64
Επισκευή και Εγγύηση
FederalCommunicationsCommission
(FCC)Notice(U.S.Only)
Note:
This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can
radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference
to radio communications. However, there
is no guarantee that interference will not
occur in a particular installation. If this
equipment does cause harmful interference
to radio or television reception, which can
be determined by turning the equipment
off and on, the user is encouraged to try to
correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving
antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet on a
circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced
radio/ TV technician for help.
Caution:
Changes or modifications not expressly
approved by the party responsible for
compliance could void the user’s authority to
operate the equipment.
Connections to this device must be made
with shielded cables with metallic RFI/EMI
connector hoods to maintain compliance
with FCC Rules and Regulations.
To prevent damage which may result in
fire or shock hazard, do not expose this
appliance to rain or excessive moisture.
THIS CLASS B DIGITAL APPARATUS
MEETS ALL REQUIREMENTS OF THE
CANADIAN INTERFERENCE-CAUSING
EQUIPMENT REGULATIONS.
FCCDeclarationofConformity
Model Number: 9FF2
Trade Name: Philips
Responsible Party: Philips
Consumer
Electronics North America
P.O. Box 671539
Marietta, GA 30006-0026
1-888-PHILIPS (744-
5477)
DeclarationofConformityforProducts
MarkedwithFCCLogo,UnitedStates
Only
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions: (1) this device
may not cause harmful interference, and
(2) this device must accept any interference
received, including interference that may
cause undesired operation.