MSDS

Philips Lighting Company

200 Franklin Square Drive

Somerset, NJ 08873-4186

Tel: 732.563.3000

A Division of

Philips Electronics North American Corporation

Philips Lighting Company

MATERIAL SAFETY DATA SHEET S06-03001

Revised: 12/2012

PRODUCT: TUV Germicidal Lamps

SECTION 1: MANUFACTURER

Manufacturer’s Name and Address: Philips Lighting Company

A Division of Philips Electronics

North America Corporation

200 Franklin Square Drive

Somerset, NJ 08873-4186

Emergency Telephone No: (800) 424-9300 CHEMTREC

(800) 555-0050 Philips Lighting Technical Information

SECTION 2: HAZARDOUS INGREDIENTS

OSHA (PEL) ACGIH (TLV) % by Wt.

mg/m

TWA

Inert Ingredients (Glass, Metal, etc.) ~ 99

Mercury (7439-97-6) .1 .025 ~0.1

Mercury is inside the lamp, breakage may result in exposure.

SECTION 3: PHYSICAL CHEMICAL CHARACTERISTICS

This item is a glass light bulb. The mercury is inside the bulb, chemical

characteristics of the bulb are not applicable. This bulb can crack if hit with a heavy

object.

PAGE 1
Philips Lighting Company MATERIAL SAFETY DATA SHEET S06-03001 Revised: 12/2012 PRODUCT: TUV Germicidal Lamps SECTION 1: MANUFACTURER Manufacturer’s Name and Address: Emergency Telephone No: Philips Lighting Company A Division of Philips Electronics North America Corporation 200 Franklin Square Drive Somerset, NJ 08873-4186 (800) 424-9300 CHEMTREC (800) 555-0050 Philips Lighting Technical Information SECTION 2: HAZARDOUS INGREDIENTS OSHA (PEL) mg/m3 Inert Ingredients (Glass, Metal, etc.
PAGE 2
SECTION 4: FIRE AND EXPLOSION DATA Glass is not a combustible, melting point is over 900°F. Fire and explosion data are not applicable. Under extreme heat, the bulb might crack or melt. SECTION 5: REACTVITY DATA Stability: Lamp is stable. Incompatibility: Glass can be attacked by hydrofluoric acid. Polymerization: Not Applicable. SECTION 6: HEALTH EFFECTS DANGER: These lamps emit ULTRAVIOLET RADIATION (UVC). Avoid exposure.
PAGE 3
SECTION 8: CONTROL MEASURES Do not operate under these lamps without personal protective equipment. (Goggles, glove, skin protection) Respiratory protection: If large numbers of these lamps are being broken an appropriate respirator should be considered. Note: Crushing of lamps on site may require a permit from state or federal authorities. We recommend recycling as the preferred disposal option.