User manual

9
2�3 Remove the Base Assembly
for VESA Mounting
Before you start disassembling the
monitor base, please follow the
instructions below to avoid any possible
damage or injury�
1� Place the monitor face down on soft
and smooth surface taking care to
avoid scratching or damaging the
screen�
2� While keeping the release button
pressed, tilt the stand and slide it
out�
Note
This monitor accepts a 100mm x 100mm
VESA-Compliant mounting interface�
VESA Mounting Screw M4� Always
contact manufacturer for wall-mount
installation�
100mm
100mm
-5°
0° 90°
* Display design may dier from those
illustrated�
Warning
• To avoid potential screen damage,
such as panel peeling, ensure that
the monitor does not tilt downward
by more than -5 degrees�
• Do not press the screen while
adjusting the angle of the monitor�
Grasp only the bezel�