Operation Manual
Table Of Contents
- Contents
- 1. Notice
- 2. Important
- 3. Get started
- 4. Use your TV
- 5. Use more of your TV
- 6. Set up your TV
- Introduction
- Benefits of specific Hotel TVs
- Professional Setup Remote control (22AV8573 optional)
- Professional mode options
- Setup settings
- PBS Setup
- TV Setup
- Change picture and sound settings (with PBS setup RC)
- More Channel Settings
- Change channel settings
- Source Selection
- Store Settings
- Smart Clone
- Welcome Logo / Hotel Information
- RF Download
- Start Download
- 7. Connect your TV
- 8. Troubleshooting
- 9. Product specifications
- 10. Index
MediaSuite xxHFL5573D/10 Page 39
English
Reinstall TV
Starts a TV initialization to reset all
settings to default and replace (reinstall)
all channels.
1. Press [Home/Menu] ] > [TV Setup>
[OK].
2. Select [Setup] > [TV settings] >
[Reinstall TV], then press OK.
TV will perform a power down cycle going
into standby and then starts-up again. If
the TV stays in Standby mode, wake TV
up with switch on button on remote
control.
1. Region OSD is displayed:
Region Australia
Europe
Select [Europe] and press <OK>.
2. Select language OSD is displayed:
Select [xxxx] (i.e. language from list) and
press <OK>.
3. Select install country OSD is
displayed:
Select [xxxx] (i.e. country from list) and
press <OK>.
4. Select TV placement OSD is
displayed:
[Wall mounted]: in case of
wall mounting
[On a TV stand]: in case of
stand
and press <OK>.
5. Universal access for the visual
and hearing impaired OSD is
displayed:
[No]: No special settings
[Yes]: Special settings
configured
and press <OK>.
6. Press [Settings] to continue and
install channels.
Perform the following steps:
[Install TV channels] and press
<OK>
[Continue]
[Settings]
A screen is displayed to make changes to
set the channel list/map configuration:
[Symbol rate mode]: Automatic
TV will use the
preset Symbol rate
(6.900/6.875)
Manual
Option to set
Symbol rate 1 and
Symbol rate 2
[Symbol rate 1]: 0.000 (to set)
[Symbol rate 2]: 0.000 (to set)
[Frequency scan]: Quick scan
Install channels
based on a pre-
configured data
table
Full scan
Install channels
based on scanning
the whole
frequency spectrum
[Frequency step]: 1 MHz
With Full scan, step
size to search for
channels is 1 MHz
8 MHz
With Full scan, step
size to search for
channels is 8 MHz