operation manual

12
2. Toggle to the up or down to select
main menu [PBP], then toggle to the
right to conrm.
3. Toggle to the up or down to select
[PBP Mode], then toggle to the right.
4. Toggle to the up or down to select
[PBP], then toggle to the right to
conrm your selection.
5. Now you can move backward to
set the [PBP Mode], [PBP Input], or
[Swap].
6. Toggle to the right to conrm your
selection.
4
MultiView in OSD menu
[PBP]: Picture by Picture
Open up a sub-window
side-by-side of another
signal source.
A (main) B
When the sub source is
not detected:
A (main) B
Note
The black strip shows on the top and
the bottom of the screen for the correct
aspect ratio when in the PBP mode. If
you expect to see full screen side by side,
adjust your devices resolutions as pop up
attention resolution, you will able to see
2 devices source screen project to this
display side by side without black strips.
[PBP Input]: There are 5 dierent video
inputs to choose as the sub
display source: [1 HDMI 2.1],
[2 HDMI 2.1], [DisplayPort1],
[DisplayPort2].
SUB SOURCE POSSIBILITY (xl)
Inputs
HDMI
1
HDMI 2 DisplayPort1 DisplayPort2
MAIN
SOURCE
(xl)
HDMI 1
● ● ● ●
HDMI 2
● ● ● ●
DisplayPort1
● ● ● ●
DisplayPort2
● ● ● ●
[Swap]: The main picture source and the
sub picture source swapped on
the display.
Swap A and B source in [PBP] mode:
A (main) B
↔
B (main) A
• O: Stop MultiView function.
Note
When you do the SWAP function, the
video and its audio source will swap at
the same time.