User manual
Table Of Contents
- Contents
- 1 Get Support
- 2 Software
- 3 Quick Guide
- 4 Setting Up
- 5 Connections
- 5.1 Connectivity guide
- 5.2 Antenna (4503, 5503, 4304, 4354, 4504, 5304, 5605-32" series TV)
- 5.3 Antenna (5505, 5525, 5535, 5605-24", 5507, 5527, 5537 series TV)
- 5.4 Satellite (if available)
- 5.5 Video Device
- 5.6 Audio Device
- 5.7 Computer
- 5.8 CAM with Smart Card - CI+
- 5.9 USB Device
- 5.10 Wired Network - Freeview (Network port is only for UK models)
- 6 Switch Source
- 7 Channels
- 8 TV Guide
- 9 Recording and Pause TV (Not applied to Turkey models)
- 10 Videos, Photos and Music
- 11 Open TV Setting Menus
- 12 Environmental
- 13 Specifications
- 14 Troubleshooting
- 15 Safety and Care
- 16 Copyrights
- 17 Open Source
- Index
press (right) to enter the menu.
4. Select Connect to network and press OK.
5. Select Wired and press OK. The TV constantly
searches for the network connection.
6. A message will be shown when the connection is
successful.
If the connection fails, you can check the DHCP
setting of the router. DHCP should be switched on.
Network Settings
(Home) > Settings > Network > View network
settings
You can view all current network settings here. The IP
and MAC address, signal strength, speed, encryption
method, etc.
(Home) > Settings > Network > Network
configuration
If you are an advanced user and want to install your
network with Static IP addressing, set the TV to Static
IP.
Select Static IP configuration and configure the
connection. You can set the number for IP
address, Netmask, Gateway, DNS.
22