operation manual
EN 47
English
Maximise display for subtitled video
Some video subtitles can create a separate
subtitle bar under the video, which limits the
video display area. To maximise the video
display area, you can switch on auto subtitle
shift and display the subtitles on the video
image.
What you need
Connect an HDMI-CEC compliant
device to the TV. You can connect
more than one HDMI-CEC device. See
Connect your TV > Connect devices
(Page 38).
Configure each HDMI-CEC compliant
device properly.
Switch on EasyLink.
Switch on EasyLink
1. Press .
2. Select [Setup] > [TV settings] > [General
settings] > [EasyLink].
3. Select [EasyLink] > [On], then press OK.
Control devices
If you connect multiple HDMI-CEC devices
that support this setting, you can control all
such devices through the TV remote control.
Note: This is an advanced setting. Devices
that do not support this setting cannot
respond to the TV remote control.
1. Press .
2. Select [Setup] > [TV settings] > [General
settings] > [EasyLink] > [EasyLink remote
control].
3. Select [On] or [Off], then press OK.
Tips:
To switch back to TV control, press ,
then select [Watch TV].
To control another device, press ,
then select the device from the Home
menu.
EasyLink buttons
You can control HDMI-CEC compliant
devices with the following buttons on the TV
remote control:
: Switch the TV and the connected
device on or to standby.
Play buttons: Control video or music
play.
Numeric buttons: Select a title, chapter
or track.
OK: Start, pause or resume play on the
connected device, activate a selection,
or access the device menu.
: Display the TV Home menu.
On-Screen Remote Control (OSRC)
You can also control devices through other
EasyLink buttons that are available through
the On-Screen Remote Control.
To access the OSRC
1. While you watch a connected device,
press OPTIONS.
2. Select [Controls], then press OK.
3. Select an onscreen button, then press OK.
4. Press to exit.
Switch off connecting devices
You can also set the TV to switch off the
connecting HDMI-CEC compliant devices if
they are not the active source. The TV
switches the connecting device to standby
after 10 minutes of inactivity.
1. Press .
2. Select [Setup] > [TV settings] > [General
settings] > [EasyLink].
3. Select [Auto switch off devices] > [On],
then press OK.