© 2004 Philips Consumer Electronics Home communication All rights reserved Printed in Hungary www.philips.
DECT5150_UK.qxd 28/06/04 16:47 Page 1 Conformity, Environment and Safety Safety information: this equipment is not designed to make emergency calls when power fails. An alternative should be made available for access to emercgency calls. Conformity : See page 12. A copy of the original certificate can be obtained on request to the customer care centre.
DECT5150_UK.qxd 28/06/04 16:47 Page 2 Line key - Press to take the line, answer a call or hang up.
DECT5150_UK.qxd 28/06/04 16:47 Page 3 The handset display The display gives information about the operation of your telephone On first use, it is sometimes necessary to wait for a few minutes of charge before seeing icons on the display. When charging, the battery bars scroll from empty to full status. When the handset discharges, the battery shows the status : Full , 2/3 , 1/3 and empty . The answer machine is activated (DECT 515).
DECT5150_UK.qxd 28/06/04 16:47 Page 4 Installing and replacing the batteries in the handset To insert the batteries, open the battery cover, place the batteries as indicated and put the battery cover back.When the handset is placed on the base station the 3 battery bars scroll (if charge is needed). Allow the handset to charge for 24 hours to reach full charge. On first use it may be necessary to wait for a few minutes before seeing symbols on the display.
DECT5150_UK.qxd 28/06/04 16:47 Page 5 Handset Registration The additional handset will get full capability when it is registered to the base station (see p. 1). You can register up to 6 handsets to the DECT 511 or DECT 515 base station.
DECT5150_UK.
DECT5150_UK.
DECT5150_UK.qxd 28/06/04 16:47 Page 8 Intercom Using the Intercom (if there are at least 2 handsets) This feature allows you to make free internal calls, transfer external calls from one handset to another, use the conference option and the babysit feature (room monitoring). Internal call Press to call the selected handset + handset number (for example ) Hang up Note: if the handset does not belong to the Philips DECT 511/515 range, this function may not be available.
DECT5150_UK.qxd 28/06/04 16:47 Page 9 The called handset rings.The external call is put on hold. If there is no answer from the called handset you can resume the call on the first handset. Take the line on the called handset, both internal callers can talk Press to select Transfer (with handset 1) Scroll to Switch and come back to the external caller Note: to answer the call on the second handset you can press .
DECT5150_UK.qxd 28/06/04 16:47 Page 10 Sounds Setting the handset sounds The ringers can be set for: - the external standard ringer for callers whose number is not stored in the phonebook or stored with no group settings. - the internal ringer for the intercom (if there are at least 2 handsets). To set the 3 group ring tones see manual DECT 511 / DECT 515.
DECT5150_UK.qxd 28/06/04 16:47 Page 11 Troubleshooting Problem No dial tone. Cause The handset is out of range, ( is not displayed). Solution Move closer to the base station and try again The handset has not been registered to the base station ( is not displayed). Register the handset to the base station (page 5) Check the connections The base station is not properly connected to the mains or the telephone line. The batteries are low ( displayed).
DECT5150_UK.qxd 28/06/04 16:47 Page 12 Declaration of conformity We, PHILIPS Consumer, Electronics Route d’Angers 72081 Le Mans Cedex 9 France Declare that the products DECT 511xx and DECT 515xx are in compliance with the Annex III of the R&TTE-Directive 1999/5/EC and then with the following essential requirements : Article 3.1.a (protection of the health & the safety of the user): EN 60950 (10/2001) Article 3.1.
© 2004 Philips Consumer Electronics Home communication All rights reserved Printed in Hungary www.philips.