User manual

Network settings
1
Press  and use  to select Setup, then press OK.
2
Use  to select Network settings, then press OK.
3
Adjust the following items.
Manual network settings
1
Use  to select Manual network settings, then press OK.
Proxy conguration
IP conguration
Wireless network setting
Network selection
Net TV
Wake-on-LAN(DIAL)
Home network
Setting status
Connection test
Manual network settings
Reset network settings
Samba interactive TV settings
N
Network selection
2
Use  to select Network selection, then press OK.
3
Use  to select the desired setting, then press OK.
Wired
If you connect to an Ethernet cable, select Wired
to connect to the internet.
Wireless
If you have a router with easy connect function,
select Wireless to connect to the internet.
Wireless network setting
This menu is displayed only when you set Wireless in Network selection.
In order to use a wireless network, you must set up a connection to the
AP (e.g. wireless router).
2
Use  to select Wireless network setting, then press OK.
Auto
Search for wireless networks automatically and select the SSID from the
list.
3
Use  to select Auto, then press OK.
4
The list of wireless networks will be displayed. Use  to select the
appropriate the SSID, then press OK.
Manually enter your SSID
Auto
Router 4
Router 3
Router 2
Router 1
Manual
Easy Connect
Pin code
•
If you select the SSID with , WEP*2 / others Key entry screen will
appear. Enter the WEP*2 / others key of the selected wireless
network using







, then press OK.
•
If you select the SSID has an easy connect, the easy connect setting
screen will appear. Use







to select a setting, then press OK.
Easy Connect
Select this setting if your router has an easy
connect button. Start scanning for wireless
networks on the TV after pressing the easy
connect button on your router. If connection test
fails, try Easy Connect again.*1 If it fails then refer
to the router’s manual for more details.
Pin code
Select this setting if your router has an easy
connect feature but does not have an easy
connect button. Enter the 8-digit PIN code shown
on your TV in the Router settings menu via PC
before Connect is selected.
Manual
If your wireless network with authentication setting
(WEP
*2, others), WEP*2 / others Key entry screen
will appear. Enter the WEP*2 / others key of the
selected wireless network using , then
press OK.
*1 Easy Connect cannot be used when the security protocol is set to
WEP. Change the Access Point’s security mode from WEP to others
(recommended).
*2 WEP is not recommended to be used due to its major security flaws.
Change the security protocol on the wireless router to others
(recommended) mode.
Confirmation message will appear. Select OK to complete the settings.
Note(s)
•
For a wireless network with authentication setting, key icon appears to the right hand of the
SSID.
•
Signal icon shows the strength of the signal.
•
WEP*2 / others key appears as asterisks on the confirmation screen.
•
The wireless LAN supports following specifications.
–Wireless standards: IEEE 802.1 1 a/b/g/n/ac
–Frequency spectrum: 2.4GHz / 5GHz
–Security protocol: WEP
*2 / others
39 .English
Continued on next page.