User manual

Table Of Contents
5 Useful tips
FAQ
Question Answer
My remote control does not
work.
What should I do?
Check the antenna or cable connection to the main unit.
Check the batteries on the remote control.
Check if there is an obstacle between the infrared sensor window and the remote control.
Test the IR signal output use IR signal check.
p. 53
If okay, then possible infrared sensor trouble.
Aim the remote control directly at the infrared sensor window on the front of the unit.
Reduce the distance to the unit.
Re-insert or replace the AAA batteries with their polarities (+/–) as indicated on the remote control battery area.
When there is an infrared-equipped device such as PC near this unit, it may interrupt the remote control signal on this unit.
Move the infrared-equipped device away from this unit, change the angle of the device's infrared sensor or turn off the
infrared communication function.
How come the initial setup
appears every time I turn on
this unit?
Make sure to complete the initial setup before the unit goes into standby mode.
Why can I not watch some RF
signal TV programs?
Autoprogram must be completed when you set up the unit for the first time or move it to a location where previously
unavailable channels are broadcast.
Make sure auto programming has been completed.
p. 35
The selected channel may not be broadcasting.
When Auto programming is interrupted and not completed, some channels will not be received. Make sure to complete
the Autoprogram.
p. 35
The selected channel cannot be viewed by the Child lock setting.
p. 36
The unit requires some kind of antenna input. An indoor antenna (Digital or VHF / UHF), an external antenna (Digital or
VHF / UHF) or an RF coaxial cable from your wall cable or set-top box needs to be plugged into the unit.
How come there is no image
from the connected external
devices?
Check if the correct input mode is selected by pressing
SOURCE.
p. 20
Check the antenna, cable or other input connection to the unit.
When using the component video connection check that the green (Y), blue (Pb/Cb) and red (Pr/Cr) connectors are
connected to their corresponding colored jacks on the unit.
When I enter a channel
number, why does it change
automatically?
Many digital channels have alternate channel numbers. The unit changes the numbers automatically to the ones signifying
the broadcasting station's channel number. These basic numbers used for the previous analog broadcasts. (e.g., input
digital ch# 30 automatically changes to digital ch# 8.1)
Why are captions not
displayed entirely?
Or why are captions delayed
behind the dialog?
Closed captions that are delayed a few seconds behind the actual dialog are common for live broadcasts. Most captioning
production companies can display a dialog to maximum of 220 words per minute. If a dialog exceeds that rate, selective
editing is used to insure that the closed captions remain up-to date with the current TV screen dialog.
How can I set the clock?
There is no clock function on this unit.
My PIN code no longer
works, how can I change the
child lock setting?
Although the default PIN code (0000) is supplied with the unit, the PIN code will be required once you set a PIN code in
Child lock.
p. 36
When you forget your PIN code, enter 07 1 1 in Change PIN to reset the PIN code.
p. 37
When I start up the TV or a
net service, a message
appears on the screen
prompting for software
update again.
When you start up the TV or a net service after executing the software update, a message may appear on the screen prompting
for software update again. In this case, please select Update to start USB update or network update.
p. 43
50 .English
Continued on next page.