Clock Radio User manual AJ210
1 7 1 8 2 3 4 5 6 # $ % ^ 9 0 ! @ &
2 3 4
English Controls Supplied accessory – 1 X certified AC 7.5V adapter (Input: 220-230V ~50Hz 30mA, Output: 7.
Clock Setting the clock and date (see 2) 1 2 • The clock uses 24-hour time format. Press and hold TIME SET for 2 seconds. ➜ The digits for year flash. Hold down or press TUNING +/- repeatedly to adjust the time digits. When it comes to adjust month and day, you may press DATE to change the display order between month and day. 3 Press TIME SET to confirm the setting. 4 ➜ The digits for month flashes. Repeat steps 2-3 to complete all the other settings for month, day, hour and minute.
Alarm 4 Press ALM 1/ALM 2 to confirm the setting. 5 ➜ AL1/AL2 icon and the minute digits flash. Hold down or press TUNING +/- repeatedly to adjust the minutes. 6 Press ALM 1/ALM 2 to confirm the setting. Helpful hints: – In standby mode, press DATE to display month and day information. In radio mode, to display alarm time, press ALM 1/ALM 2. – The currently displayed alarm time is the time for the bracketed (selected) AL1 or AL2 (See 4).
Weather forecast and Indoor thermometer – The weather forecasts from this unit are predictions that covers the next 12 to 24 hours. It may not necessarily reflect the current situation. Weather forecast The unit is capable of detecting atmospheric pressure changes. Based on the collected data, it can predict the weather in the next 12 to 24 hours.The effective range covers an area of approximately 30 to 50 km.
Safety and maintenance Safety and general maintenance • • • • • • • If you do not intend to use the clock radio for a long time, withdraw the power cord from the wall outlet. Place the set on a hard and flat surface so that the system does not tilt. Install the unit near the AC outlet and where the AC power plug can be easily reached.
Troubleshooting If a fault occurs, first check the points listed below before taking the set for repair. If you are unable to remedy a problem by following these hints, consult your dealer or service center. WARNING: Do not open the set as there is a risk of electric shock. Under no circumstances should you try to repair the set yourself, as this will invalidate the warranty. No sound. The alarm does not function. – Volume not adjusted. • Adjust the VOLUME.
English Meet Philips at the Internet http://www.philips.
