Clock Radio User manual Manuel d'utilisation Gebruikershandleidingen AJ3110
1 2 7 0 ! EAT ALAR M / S L E E P O FF % 8 REP $ T 9 4 5 6 # EA RE P 3 M / SLEEP O AR FF AL @
Important notes for users in the U.K. Mains plug This apparatus is fitted with an approved 13 Amp plug. To change a fuse in this type of plug proceed as follows: 1. Remove fuse cover and fuse. 2. Fix new fuse which should be a BS1362 3 Amp, A.S.T.A. or BSI approved type. 3. Refit the fuse cover. If the fitted plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fitted in its place. If the mains plug contains a fuse, this should have a value of 3 Amp.
• Connect the blue wire to the terminal marked N or coloured black. • Connect the brown wire to the terminal marked L or coloured red. • Do not connect either wire to the earth terminal in the plug, marked E (or e) or coloured green (or green and yellow). Before replacing the plug cover, make certain that the cord grip is clamped over the sheath of the lead - not simply over the two wires. Copyright in the U.K. Recording and playback of material may require consent.
ENVIROMENTAL INFORMATION All unnecessary packaging material has been omitted. The packaging can be easily separated into three materials: cardboard, polystyrene and plastic. Your set consists of materials which can be recycled if disassembled by a specialized company. Please observe the local regulations regarding the disposal of packaging, dead batteries and old equipment.
English CONTROLS 1 SET TIME - sets the clock time 2 SLEEP - activates the radio for sleep function 3 ALARM SET/OFF - sets the alarm time - stops the active alarm for 24 hours 4 ALARM indicator - lights up when alarm is activated 5 DISPLAY - shows the clock/ alarm time and status of the set 6 Frequency indicator - shows the radio frequency of your selected waveband 7 HOUR/MINUTE - adjusts the hours/minutes for the clock and alarm time 8 REPEAT ALARM/SLEEP OFF - switches off the active alarm for a 8-9 minute
INSTALLATION POWER SUPPLY 1 Check if the power supply, as shown on the type plate located on the bottom of the set, corresponds to your local power supply. If it does not, consult your dealer or service center. 2 Connect the power cord to the wall outlet. 3 To disconnect the set from the power supply completely, remove the plug from the wall outlet. CLOCK MEMORY BACKUP The clock memory backup allows your alarm and clock time settings to be stored for up to a day when there is a power interruption e.g.
RADIO You can use this set solely as a radio! 1 Adjust RADIO/ALARM to RADIO ON to switch on the radio. 2 Select your waveband by adjusting the BAND switch. 3 Adjust TUNING to tune to your desired station. 4 Turn the VOLUME control to adjust the volume level. 5 Adjust RADIO/ALARM to OFF to switch off the radio. To improve reception: FM: Extend and position the pigtail fully to obtain optimal reception. MW: Uses a built-in antenna inside the set. Direct the antenna by adjusting the position of your set.
SWITCHING OFF THE ALARM There are three ways of switching off the alarm. Unless you cancel the alarm completely, the 24 hour alarm reset option will be automatically selected after 1 hour and 59 minutes, from the time your alarm time first goes off. 24 HOUR ALARM RESET If you want the alarm mode to be stopped immediately but also wish to retain the same alarm setting for the following day: • Press ALARM SET/OFF during the alarm call. ™ The Alarm indicator remains on.
2 Set the sleep time to activate the sleep function by selecting one of the following ways: • Simply press SLEEP to set your sleep time to 59 mintues. • Hold down SLEEP, then press MINUTE repeatedly to adjust sleep time from 59 minutes downward. • Hold down SLEEP and press HOUR to get one more hour sleep time (1:59 hours). ™ To cancel sleep, press REPEAT ALARM/SLEEP OFF. SAFETY & MAINTENANCE • Install the unit near the AC outlet and where the AC power plug can be easily reached.
TROUBLESHOOTING If a fault occurs, first check the points listed below before taking the set for repair. If you are unable to remedy a problem by following these hints, consult your dealer or service center. WARNING: Under no circumstances should you try to repair the set yourself, as this will invalidate the warranty. Do not open the set as there is a risk of electric shock.
Clock radio Meet Philips at the Internet http://www.philips.