Clock Radio User manual AJ3120
# @ 1 2 3 4 5 6 78 SLEEP CL SE OCK SET T ALARM TIME • AL AR FM MW • ALA RM RES ET FM • S L E E P O F F • • AM CL OC K R A • DIO D N A B M •F W M M Me gah ertz Kilo her tz V 88 530 92 630 96 800 100 1000 104 1300 108 1600 Meg aher tz Kilo hert z FM MW ! 0 9 ALARM RADIO OFF•RAD•BUZ OFF• • ON M LU O E TU N IN G
English CONTROLS 1 SLEEP - activates the radio for sleep function 2 Clock control - CLOCK : to run on clock time - SET ALARM : sets the alarm time - SET TIME : sets the clock time - HR/MIN : adjusts the hours/ minutes for the clock and alarm times 3 ALARM RESET - stops the active alarm for 24 hours 4 SLEEP OFF /REPEAT ALARM - switches off the radio sleep function - switches off the active alarm for a 8-9 minute period 5 DISPLAY - show the clock/ alarm times and status of the set 6 VOLUME - adjusts the sound
INSTALLATION POWER SUPPLY 1 Check if the mains supply, as shown on the type plate located on the bottom of the set, corresponds to your local mains supply. If it does not, consult your dealer or service centre. 2 Connect the mains lead to the wall socket. 3 To disconnect the set from the mains supply completely, remove the plug from the wall socket. CLOCK MEMORY BACKUP The clock memory backup allows your alarm and clock time settings to be stored for up to a day when there is a power interruption e.g.
RADIO You can use this set solely as a radio! 1 Adjust RADIO OFF • ON to ON to switch on the radio. 2 Select your waveband by adjusting the BAND switch. 3 Adjust TUNING to tune to your desired station. 4 Turn the VOLUME control to adjust the volume level. 5 Adjust RADIO OFF • ON to OFF to switch off the radio. To improve reception: FM: extend and position the pigtail for optimum reception. uses a built-in aerial inside the set. Direct the aerial by adjusting the AM: position of your set.
SWITCHING OFF THE ALARM There are three ways of switching off the alarm. Unless you cancel the alarm completely, the 24 hour alarm reset option will be automatically selected after 1 hour and 59 minutes, from the time your alarm time first goes off. 24 HOUR ALARM RESET If you want the alarm mode to be stopped immediately but also wish to retain the same alarm setting for the following day: • Press ALARM RESET during the alarm call.
AUSTRALIA - Philips Manufacturers Warranty for Australia only These warranty conditions are valid for the following consumer electronics products: Colour Televisions, Projection TV, Plasma & LCD TV, Video Cassette Recorders, CD Recorders & Players, DVD Players, DVD Recorders, DVD Recorders with HDD, Audio Systems, Home Theatre systems, Digital Set Top Box & Portable Audio products.
SAFETY & MAINTENANCE INFORMATION • Install the unit near the AC outlet and where the AC power plug can be easily reached. • The apparatus shall not be exposed to dripping or splashing. • If you do not intend to use the set for a long time, withdraw the mains plug from the wall socket. In addition to this, it is advisable to remove the battery from the clock radio. This will prevent any danger of leakage and the clock radio will not be damaged.
TROUBLESHOOTING If a fault occurs, first check the points listed below before taking the set for repair. If you are unable to remedy a problem by following these hints, consult your dealer or service centre. WARNING: Under no circumstances should you try to repair the set yourself, as this will invalidate the guarantee. Do not open the set as there is a risk of electric shock.
NEW ZEALAND - Guarantee and Service for New Zealand Thank-you for purchasing this quality Philips product. Philips New Zealand Ltd guarantees this product against defective components and faulty workmanship for a period of 12 months. Any defect in materials or workmanship occurring within 12 months from the date of purchase subject to the following conditions will be rectified free of charge by the retailer from whom this product was purchased. Conditions 1.
Printed in China AJ 3120 - Clock radio Printed in China PDCC-0652
