Register your product and get support at www.philips.
a b
c d SLEEP 15 30 60 OFF 90 120
e 1 2 PRESET/ SET TIME 3 HOUR 2 sec 4 MIN PRESET/ SET TIME
f 1 2 RADIO ON/OFF 2 sec TUNING MIN 3 4 TUNING HOUR 2 sec VOL VOL
g 1 2 2 sec 3 HOUR 4 MIN
h AL1 FM AL1
1 • • • • • • • • • • • • Important Read these instructions. Heed all warnings. Follow all instructions. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and the point where they exit from the clock radio.
• 2 Where the plug of the Direct Plug-in Adapter is used as the disconnect device, the disconnect device shall remain readily operable. Your clock radio Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips. com/welcome. What’s in the box (Fig. 3 ) Get started Always follow the instructions in this chapter in sequence. Install battery The battery can only back up clock and alarm settings.
Caution •• Risk of explosion! Keep the battery away from heat, sunshine or fire. Never discard battery in fire. •• The battery contains chemical substances, so it should be disposed of properly. Insert one 9V 6F22 battery (not supplied) with correct polarity (+/-) as illustrated. (Fig. ) Tip •• The display backlight is off when AC power is disconnected. Connect power (Fig.
Set time (Fig. ) Note •• You can only set time in standby mode. 4 Listen to FM radio Note •• Keep the clock radio away from other electronic devices to avoid radio interference. •• For better reception, fully extend and adjust the position of the FM antenna. Tune to FM radio stations (Fig. Store FM radio stations manually You can store up to 10 FM radio stations. 1 2 Tune to an FM radio station. Press and hold PRESET for two seconds. »» The preset number begins to blink.
3 4 5 Press TUNING repeatedly to select a number. Press PRESET again to confirm. Repeat steps 1 to 4 to store other stations. Tip •• To remove a pre-stored station, store another station in its place. Select a preset radio station In tuner mode, press PRESET repeatedly to select a preset number.
5 Other features Set alarm timer Set alarm Note •• You can only set the alarm in standby mode. •• When alarm sounds, volume rises gradually. You cannot adjust the alarm volume manually. •• Make sure that you have set the clock correctly. Follow the illustration to set the first alarm. (Fig. • AL1: set the first alarm. • AL2: set the second alarm. ) Tip •• The clock radio exits alarm setting mode when being idle for 10 seconds. Select alarm source You can select FM radio or buzzer as the alarm source.
Activate/deactivate alarm timer Press AL1 or AL2 repeatedly to activate or deactivate the alarm timer. »» If the alarm timer is deactivated, the alarm indicator turns off. »» The alarm repeats ringing for the next day. Snooze alarm When alarm sounds, press SNOOZE. »» The alarm snoozes and repeats ringing nine minutes later. Set sleep timer This clock radio can switch to standby mode automatically after a preset period. (Fig.
6 Product information Note •• Product information is subject to change without prior notice. Specifications Amplifier Total Output Power 200 MW Tuner (FM) Tuning range 87.5-108 MHz Tuning grid 50 KHz Sensitivity - Mono, 26 dB S/N Ratio - Stereo, 46 dB S/N Ratio <22 dBf <51.
General information AC power (power adapter) Brand name: Philips; Model: AS030-060-EE050; Input: 100-240 V~, 50/60 Hz; 0.15 A; Output: 6 V 0.5 A Operation Power Consumption <5 W Standby Power Consumption <1 W Dimensions: Main Unit (W x H x D) 177 x 48 x 123 mm Weight: -Main Unit -With Packing 0.3 kg 0.
7 Troubleshooting Warning •• Never remove the casing of this apparatus. To keep the warranty valid, never try to repair the system yourself. If you encounter problems when using this apparatus, check the following points before requesting service. If the problem remains unsolved, go to the Philips web site (www.philips.com/support). When you contact Philips, ensure that the apparatus is nearby and the model number and serial number are available.
8 Notice Any changes or modifications made to this device that are not expressly approved by Philips Consumer Lifestyle may void the user’s authority to operate the equipment. This product complies with the radio interference requirements of the European Community. Your product is designed and manufactured with high quality materials and components, which can be recycled and reused.
batteries because correct disposal helps to prevent negative consequences for the environmental and human health. Environmental information All unnecessary packaging has been omitted. We have tried to make the packaging easy to separate into three materials: cardboard (box), polystyrene foam (buffer) and polyethylene (bags, protective foam sheet.) Your system consists of materials which can be recycled and reused if disassembled by a specialized company.
All registered and unregistered trademarks are property of their respective owners. © 2012 Koninklijke Philips Electronics N.V. All rights reserved. AJ3123_12_UM_V1.