Register your product and get support at www.philips.
a b
d SLEEP 15 30 60 OFF 90 120
e 1 2 PRESET/ SET TIME 3 HOUR 2 sec 4 MIN PRESET/ SET TIME
f 1 2 RADIO ON/OFF 2 sec TUNING MIN 3 4 TUNING HOUR 2 sec VOL VOL
g 1 2 2 sec 3 HOUR 4 MIN
h AL1 FM AL1
1 • • • • • • • • • • Important Read these instructions. Heed all warnings. Follow all instructions. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and the point where they exit from the clock radio.
• • • 2 This clock radio shall not be exposed to dripping or splashing. Do not place any sources of danger on the clock radio (e.g. liquid filled objects, lighted candles). Where the plug of the Direct Plug-in Adapter is used as the disconnect device, the disconnect device shall remain readily operable. Your clock radio Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/support.
Caution •• Risk of explosion! Keep the battery away from heat, sunshine or fire. Never discard battery in fire. •• The battery contains chemical substances, so it should be disposed of properly. Insert 2 AAA batteries (not supplied) with correct polarity (+/-). (Fig. ) Tip •• The display backlight is off when AC power is disconnected. Connect power (Fig. ) Caution •• Risk of product damage! Make sure that the power voltage corresponds to the voltage printed on the back or underside of the clock radio.
Set time (Fig. ) Note •• You can only set time in standby mode. 4 Listen to FM radio Note •• Keep the clock radio away from other electronic devices to avoid radio interference. •• For better reception, fully extend and adjust the position of the FM antenna. Tune to FM radio stations (Fig. ) Store FM radio stations manually You can store up to 10 FM radio stations. 1 2 Tune to an FM radio station. 3 4 Press Press and hold PRESET for two seconds. »» The preset number begins to blink.
5 Repeat steps 1 to 4 to store other stations. Tip •• To remove a pre-stored station, store another station in its place. Select a preset radio station In tuner mode, press PRESET repeatedly to select a preset number. 5 Other features Set alarm timer Set alarm Note •• You can only set the alarm in standby mode. •• Make sure that you have set the clock correctly. Follow the illustration to set the first alarm. (Fig. • AL1: set the first alarm. • AL2: set the second alarm.
Tip •• The clock radio exits alarm setting mode when being idle for 10 seconds. Select alarm source You can select FM radio or buzzer as the alarm source. (Fig. »» The corresponding alarm icon lights up. ) Note •• If FM radio is selected as alarm source, when alarm sounds, volume rises gradually. You cannot adjust the alarm volume manually. •• If Buzzer is selected as alarm source, the alarm volume will be at default level and cannot be adjusted.
Set sleep timer This clock radio can switch to standby mode automatically after a preset period. (Fig. ) To deactivate the sleep timer: • Press SLEEP repeatedly until [OFF] (off) appears. 6 Product information Note •• Product information is subject to change without prior notice. Specifications Amplifier Total Output Power 200 MW Tuner (FM) Tuning range 87.
Sensitivity - Mono, 26 dB S/N Ratio - Stereo, 46 dB S/N Ratio <22 dBf <51.5 dBf Total Harmonic Distortion <3% Signal to Noise Ratio >50 dBA General information AC power (power adapter) Brand name: Philips; Model: AS030-060-EE050/ EML0600500; Input: 100-240 V~, 50/60 Hz; 0.15 A; Output: 6 V 0.5 A Operation Power Consumption <5 W Standby Power Consumption <1 W Dimensions: Main Unit (W x H x D) 177 x 48 x 123 mm Weight: -Main Unit -With Packing 0.3 kg 0.
To keep the warranty valid, never try to repair the system yourself. If you encounter problems when using this apparatus, check the following points before requesting service. If the problem remains unsolved, go to the Philips web site (www.philips.com/support). When you contact Philips, ensure that the apparatus is nearby and the model number and serial number are available. No power •• Ensure that the AC power plug of the unit is connected properly. •• Ensure that there is power at the AC outlet.
8 Notice Any changes or modifications made to this device that are not expressly approved by Gibson Innovations may void the user’s authority to operate the equipment. This product complies with the radio interference requirements of the European Community. Your product is designed and manufactured with high quality materials and components, which can be recycled and reused.
Your product contains batteries covered by the European Directive 2006/66/EC, which cannot be disposed with normal household waste.Please inform yourself about the local rules on separate collection of batteries because correct disposal helps to prevent negative consequences for the environmental and human health. Environmental information All unnecessary packaging has been omitted.
2015 © Gibson Innovations Limited. All rights reserved. This product has been manufactured by, and is sold under the responsibility of Gibson Innovations Ltd., and Gibson Innovations Ltd. is the warrantor in relation to this product. Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V. and are used under license from Koninklijke Philips N.V. AJ3123_12_UM_V5.
